Precor 903 owner manual Diagram

Page 22

Diagram 17

+

5.Reinsert two fresh batteries. Remove the existing batteries from the unit and reinsert two fresh (A-76 type) alkaline batteries. The positive (+) side should be facing you. See Diagram 17.

Note: All the LCD segments momentarily appear when the fresh batteries are installed.

6.Replace the back of the electronic console by inserting the four Phillips head screws back into place. Tighten the screws using the Phillips head screwdriver.

7.Reconnect the reed switch wire into the console. For the 903 treadmill, be sure to route the wire through the hole on the handrail clamp before reconnecting the wire.

8.Slide the console back onto the mounting bracket.

9.Reset the display by pressing all three buttons (SELECT, CLEAR, and SET) at the same time.

10.Press the SELECT button if you wish to turn the electronic console ON.

page 22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Assembly and Operation Electronic ConsoleSafety Information Obtaining ServiceTable of Contents Before You Begin Unpacking the Electronic ConsoleInstalling the Electronic Console Assembly ProceduresDiagram Diagram Continue to Installing the Mounting Pads Assembly Procedures Diagram Diagram Installing the Mounting Pads Diagram Attaching the Magnet and Reed Switch Diagram Secure the handrails into an upright position Using the Electronic Console Electronic Console ButtonsElectronic Console Displays Setting the Timer Maintaining the Electronic Console Replacing the BatteriesDiagram Diagram Appendix a USA
Related manuals
Manual 27 pages 25.2 Kb Manual 20 pages 30.71 Kb
Top Page Image Contents