Weider 831.15392.2 user manual

12.Attach a Plastic Foot (53) to the Backrest Frame (15) with an M4 x 16mm Screw (62).

Attach the two Guard Plates (17) to the inside of the Backrest Frame (15) with four M4 x 16mm Screws (62).

13.Orient the Backrest (14) as shown. Attach the Backrest to the Backrest Frame (15) with four 1/4” x 45mm Screws (58).

Insert the rod on the Backrest Frame (15) into the slot in the Seat Carriage (12). Hold the Backrest

Frame vertically over the Seat Carriage and slide the rod into the slot, as shown in the inset drawing.

14.Attach the two 10-pound Short Resistance Bar Caps (20) to the 10-pound Center Resistance Bar (44) with two M4 x 12mm Flat Head Screws (85).

Using twelve M4 x 12mm Flat Head Screws (85), attach the two 10-pound Resistance Bar Caps

(18)to the 10-pound Resistance Bar (67), the two 20-pound Resistance Bar Caps (88) to the 20- pound Resistance Bar (36), the four 80-pound Resistance Bar Caps (37) to the two 80-pound Resistance Bar (95), and the two 40-pound Resistance Bar Caps (79) to the 40-pound Resistance Bar (96).

12			15
					53
					62
			62
	17	62
			17
13
14
					15
					Rod
15					Slot
		58			12
14
				95	96
			36		79
					85
			67
		44			85
				85	37
			85		88
	85		20	18

9