JVC CA-MXG51R Listening to FM, MW, and LW Broadcasts, Tuning in a Station, Presetting Stations

Listening to FM, MW, and LW Broadcasts

Tuning in a Station

1 Press FM/AM.

The unit automatically turns on and tunes in the previously tuned station (FM, MW or LW).

•Each time you press the button, the band changes among FM, MW, and LW.

2 Start searching for stations. On the unit:

Press and hold TUNING + or

2 Press SET. SET

3 Press PRESET + or PRESET –

PRESET

to select a preset number.

TUNING – for more than 1

second.

On the remote control:

Press and hold 4or

¢for more than 1 second.

TUNING

4 Press SET again. SET

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

If a program is broadcast in stereo, the ST (stereo) indicator lights up.

To stop during searching, press TUNING + or TUNING – (or 4or ¢ on the remote control).

When you press TUNING + or TUNING –

(or 4or ¢on the remote control) briefly and repeatedly

The frequency changes step by step.

To change the FM reception mode

When an FM stereo broadcast is hard to receive or

noisy, press FM MODE on the remote control so that FM MODE “MONO” appears and the MONO indicator lights up

on the display. Reception improves.

To restore the stereo effect, press FM MODE

again so that “STEREO” appears on the diplay and the MONO indicator goes off from the display.

In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo.

Presetting Stations

You can preset 30 FM, 8 MW, and 7 LW stations.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the unit ONLY:

1 Tune in the station you want to preset.

• See “Tuning in a Station” above.

The tuned station in step 1 is stored in the preset number selected in step 3.

•Storing a new station on a used number erases the previously stored one.

When you unplug the AC power cord or if a power failure occurs

The preset stations will be erased in a few days. If this happens, preset the stations again.

Tuning in a Preset Station

1 Press FM/AM.

The unit automatically turns on and tunes in the previously tuned station (FM, MW or LW).

•Each time you press the button, the band changes among FM, MW, and LW.

2 Select a preset number.

On the unit:

PRESET

Press PRESET + or PRESET –.

On the remote control:

Press the number buttons.

Ex.: For preset number 5, press 5.	1	2	3
For preset number 15, press +10 4		5	6
then 5.	7	8	9
For preset number 20, press
	10	+10
+10, then 10.

For preset number 25, press +10, +10, then 5.

For preset number 30, press +10, +10, then 10.

– 11 –