Weider 831.159820 user manual

37.Remove the preattached 3 1/2” Pulley (not shown) from the “U”-Bracket (85).

Attach the end of the Leg Lever Cable (96) to the other “U”-Bracket (85) with a 1/4” Washer (35) and a 1/4” Nylon Locknut (65). Note: Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset draw- ing.

38.Locate the Low Cable (47). Route the small ball on the Cable through the cage on the Leg Press Frame (30).

Attach a 3 1/2” Pulley (38) inside the Leg Press Frame (30) with a 3/8” x 2 3/4” Bolt (81), two 3/8” Washers (75), two 1/2” Spacers (34), and a 3/8” Nylon Locknut (70).

39.Route the Low Cable (47) through the Left Leg (36) and the Left Upright (7). Attach a 3 1/2” Pulley (38) inside the Upright with a 3/8” x 2 3/4” Bolt (81), two 3/8” Washers (75), two 1/2” Spacers (34), and a 3/8” Nylon Locknut (70).

40.Wrap the Low Cable (47) around a 3 1/2” Pulley

(38).Attach the Pulley and a Cable Trap (91) to the lower set of holes in the indicated “U”-Bracket

(85)with a 3/8” x 2” Bolt (62) and a 3/8” Nylon Locknut (70). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.

37
	96		96
	35
			65
85	65
38
		30
	38	34	70
			75
34			Cage
81	75		47
39
		34
38		75
		70
		47
		36
34
75	7
81
40
	85
	62	70
		91
	38
		47

16