6.Orient the Left Dip Arm (4) as shown, so that the large hole is on top. Attach the Left Dip Arm to the left Upright (2) with a 3/8” x 2.85” Bolt (23), two 3/8” Washers (18), and a 3/8” Nylon Locknut (19). Do not tighten the Nylon Locknut yet.
Attach the Left Dip Arm (4) to the left Upright Base (3) with two 3/8” x 3/4” Bolts (22) and two 3/8” Washers (18). Do not tighten the Bolts yet.
Repeat this step with the Right Dip Arm (not shown).
7.Orient the Top Crossbar (6) with the bracket on the side shown. Attach the Top Crossbar to each Dip Arm (4, 25) with two 3/8” x 2.85” Bolts (23), four 3/8” Washers (18), and two 3/8” Nylon Locknuts (19). Do not tighten the Nylon
Locknuts yet.
8.Slide a Handgrip (12) onto each end of the Pull- up Bar (1). Attach the
(2) with two 3/8” x 2” Bolts (21) and two 3/8” Washers (18).
Tighten all of the Bolts and Nylon locknuts used in steps 2–8.
9.Attach a Handle (8) to each Dip Arm (4, 25) with a 3/8” x 3/4” Bolt (22) and a 3/8” Washer (18). Slide a Handgrip (12) onto each Handle.
Slide a Bushing (13) and a Handgrip (12) onto each Dip Arm (4, 25).
8
6 |
|
|
|
|
Large Hole |
|
|
|
|
19 |
| 18 | 2 | |
|
| |||
4 |
|
| 18 |
|
|
| 23 |
| |
|
|
| 3 | |
|
|
|
| |
22 |
|
|
|
|
| 18 | 22 |
| |
|
|
|
| |
7 |
|
| 18 | 23 |
|
|
| ||
|
|
| 6 | |
Bracket |
|
| ||
|
|
| ||
18 |
|
|
| 18 |
|
|
|
| |
|
|
| 19 |
|
23 |
|
| 18 |
|
|
|
|
| |
4 |
|
| 25 |
|
|
|
|
| |
8 |
|
| 1 |
|
2 |
|
|
| |
|
|
|
| |
2 |
|
|
| 12 |
|
|
| 18 | 21 |
|
| 18 | ||
|
|
| ||
12 |
|
| 21 |
|
|
|
|
| |
9 |
|
|
|
|
12 |
|
|
|
|
12 | 8 |
|
| |
|
|
| ||
13 |
| 4 | 25 | |
|
|
|
| |
18 |
|
|
|
|
22 |
|
|
| |