7.Attach the Backrest (7) to the Backrest Frames (33) with four M6 x 38mm Screws (37) and four M6 Washers (36). Make sure that the Backrest is oriented as shown. Do not tighten the Screws yet.
8.Lubricate an M10 x 180mm Bolt (35) with grease. Attach the Backrest Frames (33) to the Bench Frame (1) with the Bolt, two M10 Washers (6), and an M10 Nylon Locknut (11). Do not over- tighten the Locknut; the Backrest must be able to pivot freely.
Slide the Backrest Bracket (5) into the indicated slot on the Bench Frame (1). Engage the Bench Pin (21) into an adjustment hole in the Backrest Bracket. Attach the tether on the Pin to the bot- tom of the Bench Frame with the M4 x 16mm Screw (71).
Tighten the M6 Nylon Locknuts (40) and the M6 x 36mm Screws (37) used in steps 6 and 7.
9.Attach the Seat (20) to the Bench Frame (1) with four M6 x 16mm Screws (30). Make sure that the Seat is oriented as shown.
10.Press two 19mm Round Inner Caps (18) into the ends of the three Pad Tubes (17). Slide the Pad Tubes through the indicated holes in the Front Leg (3) and the Leg Lever (8).
Slide two Foam Pads (19) onto each Pad Tube (17).
7 |
|
|
7 |
| 33 |
|
| |
Wide |
| 36 |
End |
|
|
36 | 37 |
|
36 |
| |
37 |
| |
37 |
| |
|
| |
8 |
|
|
Lubricate | 33 |
|
|
| |
6 |
|
|
35 |
|
|
1 |
|
|
5 | 6 | |
| ||
71 | 21 | 11 |
9 |
|
|
Wide |
|
|
End |
|
|
20 |
|
|
| 1 |
|
| 30 |
|
10 |
|
|
19 | 3 |
|
|
| |
8 |
|
|
19 | 18 |
|
18 |
| |
| 17 | |
|
| |
17 |
| 18 |
18 |
| 19 |
|
| |
| 19 |
|
7