28.Slide the four Foam Pads (26) onto the tubes on the Front Leg (6) and the Leg Lever (7). Press the four 19mm Round Inner Caps (78) into the ends of the tubes.
29.Attach the “FLEX CTX 60” exercise decal to the Upright Base (3) and the Upright (4). The decal should be centered on the Upright Base and Upright, and the top of the decal should be six inches below the Top Frame (9). Be careful not to wrinkle the decal.
28 |
|
|
|
|
|
| 78 |
|
|
| 26 |
|
|
| 78 |
|
| 26 | 26 |
|
|
| |
| 78 |
| 6 |
|
| 26 | |
|
| 7 | |
|
|
| |
|
| 78 |
|
29 |
| 9 |
|
|
|
| |
6” |
| 4 |
|
|
|
| 3 |
30.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull the long cable a few times to be sure that it move smoothly over the pulleys. If the cable does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 17 for proper cable routing.
13