Weider WESY99490 manual Nylon Locknuts yet, Nylon Locknut the Leg Press Lever must pivot easily

9.Press a 2Ó Square Inner Cap (28) into the Press Seat Frame (7).

Slide the bracket on the Press Seat Frame (7) onto the indicated 5/16Ó x 2 1/2Ó Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16Ó Nylon Locknuts (64) onto the Bolts. Do not tighten the

Nylon Locknuts yet.

Attach the Press Seat Frame (7) to the Press Upright

(2) with two 5/16Ó x 2 3/4Ó Bolts (89), two 5/16Ó Washers (36), and two 5/16Ó Nylon Locknuts (64). Do not tighten the Nylon Locknuts yet.

10.Lubricate the 3/8Ó x 3Ó Bolt (88). Attach the Leg Press Lever (83) to the Press Base (6) with the Bolt and a 3/8Ó Nylon Locknut (50). Do not overtighten the

Nylon Locknut; the Leg Press Lever must pivot easily.

11.Place two Weight Bumpers (51) over the indicated holes in the Weight Base (5). Slide a Weight Guide

(15)into each of the holes.

Attach the indicated Weight Guide (15) to the Weight Base (5) with a 3/8Ó x 2 3/4Ó Bolt (46), two 3/8Ó Flat Washers (48), and a 3/8Ó Nylon Locknut (50).

Slide six Weights (21) onto the Weight Guides (15).

Make sure the Weights are turned so the pin grooves point towards the floor.

Press a Weight Tube Bumper (18) into the lower end of the Short Weight Tube (17). Slide the Weight Tube into the center holes in the Weights (21).

Slide a Top Weight (16) onto the Weight Guides (15).

Note: Make sure the Top Weight is turned so the groove fits over the welded pin on the Weight Tube (17).

8

9		89	36
	7		64
			36
28
		89
64	64		2
			6
	92
10
	83
			6
	50		Lubricate
			88
11	15
	16
	Groove
	Pin
	17
		18
	21
Pin
Grooves
		51
		48
			50
	5
	48
	46