Weider WESY59100 user manual Trap is turned to hold the Cable in place

23.Remove the preassembled 3/8” x 2” Bolts (54) from one set of Adjustable Pulley Plates (23).

Wrap the Butterfly Cable (73) around a 3 1/2” Pulley (24). Attach the 3 1/2” Pulley and a Cable Trap (25) between the top holes of the Adjustable Pulley Plates (23) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50). Be sure that the Cable

Trap is turned to hold the Cable in place.

24.Wrap the Butterfly Cable (73) around a “V”-Pulley

(27).Attach the “V”-Pulley and a Large Cable Trap

(32)to the bracket on the Butterfly Upright (1) with a 3/8” x 2 1/2” Bolt (87) and a 3/8” Nylon Locknut

(50).Be sure that the Cable Trap is turned to hold the Cable in place.

25.Secure a 3/8” x 2 1/4” Bolt (79) to the Left Pivot Arm (71) with a 3/8” Nylon Jamnut (63).

Attach the Butterfly Cable (73) to the 3/8” x 2 1/4” Bolt (79) with a 3/8” Nylon Jamnut (63). Note: Do not fully tighten the Nylon Jamnut; the Butterfly Cable must be able to pivot easily.

26.Locate the Ab Cable (47). Insert the Ab Cable up through the Press Top Frame (9) and wrap it around a 3 1/2” Pulley (24). Attach a 3/8” Flat Washer (48) and a 5/8” x 3/4” Bushing (66) to a 3/8” x 3 1/4” Bolt (62). Slide the Bolt through the Press Top Frame and the 3 1/2” Pulley. Secure another 5/8” x 3/4” Bushing and 3/8” Flat Washer to the Bolt with a 3/8” Nylon Locknut (50).

12

23
54	24
25
	73
	50
23
24	87
32
50	27
	73
	1
25
73
	63
	71
	79
26
66
24
62	9
48
48	50
47