Weider WESY7773.1 Rods on the Fulcrum. Make sure the Tray is ori, Ented as shown in the drawing

16. Locate the Fulcrum (18) on the Lat Tower (4) (see	16
the inset drawing). Slide the Tray (35) onto the
			86
rods on the Fulcrum. Make sure the Tray is ori-
				Back
ented as shown in the drawing.
Set the Resistance Bars into the Tray (35) in the				72
following order: the 10-pound Removable
Resistance Bar (67), the 20-pound Removable
Resistance Bar (36), an 80-pound Resistance Bar
(95), the 10-pound Center Resistance Bar (44), an	Rings on				96
80-pound Resistance Bar (95), and the 40-pound
	this side		44
Resistance Bar (96). Make sure the indicated
rings are on the side shown and the arrows		4			95
point toward the Tray.		35
Orient the Cover Plate (72) as shown with the		18			95
					36
back facing away from the Lat Tower (4). Attach		18	Rods	67
the Cover Plate to the Tray (35) with two M8 x
19mm Button Head Screws (86).	17
				80	71
17. Locate the Long Cable (80). Insert one end of				11	104
the Cable through the welded tube on the indicat-
ed end of the Cross Tube (11) and then through a					22
Swivel Arm (22). If necessary, use the tip of a			28
screwdriver to pull the end of the Cable out of the
Swivel Arm. Make sure the Cable is on the indi-					Rod
cated side of the welded rod in the Swivel Arm.					76
Insert the Swivel Arm (22) into the welded tube
on the Cross Tube (11). Secure the Swivel Arm
with an M4 x 5mm Screw (104).
Wrap the Long Cable (80) around a 90mm Pulley	18		Flat
(28). Attach the Pulley inside of the Swivel Arm
			Edge	29	76
(22) with an M10 x 42mm Button Head Bolt (71)
and an M10 Nylon Locknut (76).
18. Wrap the Long Cable (80) around a 90mm Pulley		73			80
(28). Attach the Pulley and a Pulley Guard (29) to					28
the indicated M10 x 140mm Carriage Bolt (73)
with an M10 Nylon Locknut (76). Be sure the flat
edge of the Pulley Guard is on the side shown.
	19
19. Attach a Pulley Housing (94) to the indicated “U”-
channel on the 10-pound Center Resistance Bar
(44) with an M10 x 102mm Button Head Bolt (24),
two Pivot Bushings (74), and an M10 Nylon
Locknut (76).		44
Wrap the Long Cable (80) over a 90mm Pulley		76
				“U”-Channel
(28). Attach the Pulley inside of the Pulley		74
Housing (94) with an M10 x 42mm Button Head		71		76
Bolt (71) and an M10 Nylon Locknut (76).			94
		28	74
		80	24
	10