Maintenance
Water inlet valve and inlet valve filter
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve filter regularly.
Moving the machine
If the machine is to be moved to a distant loca | , replace the transportamoved before |
installato prevent damage as shown below.
Remove the back cover.
Remove the blanking plugs.
Insert the synthe | and the transportabolts. |
Tighten the bolts with a spanner.
Replace the back cover.
Long periods of disuse
If the washing machine is leor a long period, pu | ll out the electrical plug and turn off the water |
supply. Open the washer door to prevent formaof | moisture and odors. Let the door open while |
not used. |
|
Display Codes |
|
Display Codes and Special func |
Codes
Err1
Err2
Err3
Err4
Err5
Causes
Door is not properly shut.
Drainage error, water not empwithin 6 minutes.
Temperature sensor not properly
connected or damaged.
Heater error (Appears at the end of a cycle).
Water level not met in 8 minutes.
The height of the drain hose is below 80 cm.
The drain hose is in water.
Solu
Shut the door properly, and then press the Start/Pause bun.
Clean the filter and check the drain hose for blockage. If error sists, please contact the maintenance personnel.
Contact the maintenance personnel.
Contact the maintenance personnel.
Make sure that tap is turned on, and water pressure is normal.
If problem s exists, please contact the maintenance personnel.
Install drain hose within
Make sure the drain hose is not in water.
18