
Before Use
Inon
Adjus
ng the b
om cover
Before removing the transpoon bolts, please fix the bo
om cover to the bo
om of the washing machine. Lay down the machine (fig.1), screw off the feet and adjust the bo
om cover with the four holes corresponding to the screw holes of the feet. Then screw the feet back on through the cover and fix it thus securely to the bo
om of the machine (fig 2.).
It keeps out the dampness and reduces the noise.
Dismantle the transport
on bolts
The transpoon bolts are designed for clamping an
- vib
on components inside of the washing machine during the transpo
on process.
Remove the back cover.
Remove the four bolts on the rear side and take out the sync stabilizers from within the machine.
Replace the back cover.
Fill the holes le by the bolts with blanking plugs.
Note:
When you replace the back cover, the convexity
must face to outside, and you have to insert the back cover from the two gaps as shown in fig.5. Keep the transporta
on bolts and synthe
c
stabilizers in a safe place for later use.
5.
Adjus
ng the feet
There are adjustable feet under the boom of the washing machine. Before use, they should be adjusted so that the machine is level. This will minimize vibr
ons and thus noise during use. It will also reduce wear and tear. We recommend using a spirit level to level the appliance. The floor should be as stable and flat as possible.
6