Before You Call (continued)
Check these points if your clothes washer...
Stops
Leaks Water
Is Noisy
Fills with
the Wrong
Temperature
Water
•Unevenly distributed load. Redistribute the load, close the lid and pull knob out. Check for leveling. Be sure water level is acceptable for load size.
•Plug cord into live electrical outlet.
•Check fuse or reset circuit breaker.
•Turn the control knob to proper cycle and pull knob out to start the washer. If equipped with buttons, be sure they are fully depressed.
•Close lid and pull control knob out to start the washer. For your safety, wash- er will not fill, agitate or spin unless lid is closed.
•This may be a pause or soak period in the cycle. Wait briefly and it may start.
•Make sure hose connections are tight.
•Make sure end of drain hose is correctly inserted and secured to drain facility.
•Avoid extended soaking – soak for 30 minutes or less.
•Avoid overloading.
•Be sure washer is leveled properly as outlined in installation manual.
•Weak floors can cause vibration and walking.
•Be sure rubber feet are installed on leveling legs.
•Turn both faucets on fully.
•If equipped with a temperature selector knob, be sure it is set directly on a temperature setting and not between settings.
•Make sure temperature selection is correct.
•Make sure hoses are connected to correct faucets and inlet connections. Flush water line before filling washer.
•Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap. Also check water heater capacity and recovery rate.
•Disconnect hoses and clean screens. Hose filter screens may be plugged.
For further assistance contact Maytag Appliances Sales Company, Maytag Customer Assistance:
U.S.
U.S. customers using TTY for deaf, hearing impaired or speech impaired, call
12