Recessed area or closet installation
The dimensions shown are for the recommended spacing allowed (A and B), except the closet door ventilation openings. The dimensions shown for the closet door ventilation openings (C) are the minimum required.
The top of the standpipe must be at least 39" (99 cm) high and no higher than 96" (244 cm) from the bottom of the washer.
To avoid siphoning, no more than 8" (20.3 cm) of drain hose should be inside the standpipe. Secure drain hose with beaded tie strap.
19" 
(48.3 cm)
0" |
| 27" |
| ||
(0 cm) | (68.6 cm) | |
A
|
|
|
|
| 3" |
|
| 14" max. | 48 in.2 |
| (7.6 cm) |
|
|
|
| ||
|
| (35.6 cm) | (310 cm 2 ) |
| |
|
|
| 2 |
|
|
|
|
| 24 in. |
| 3" |
|
|
| (155 cm2 | ) | |
|
|
|
|
| (7.6 cm) |
0" | 1" | 25¹⁄₂" | 4" |
|
|
(0 cm) | (2.5 cm) | (64.8 cm) | (10.2 cm) |
| |
BC
A. Front view
B. Side view
C. Closet door with vents
39"
(99 cm)
AB
Laundry tub drain system (view C)
■Additional spacing should be considered for ease of installation and servicing.
■Additional clearances may be required for wall, door and floor moldings.
■Additional spacing of 1" (2.5 cm) on all sides of the washer is recommended to reduce noise transfer.
■If a closet door is installed, the minimum air openings in the top and bottom of the door are required (C). Louvered doors with air openings in the top and bottom are acceptable.
■Companion appliance spacing should also be considered.
Drain System
The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. Select the drain hose installation method you need. See “Tools and Parts.”
Standpipe drain system - wall or floor (views A & B)
The standpipe drain requires a minimum diameter standpipe of 2" (5 cm). The minimum
The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 39" (99 cm) above the floor and no higher than 96" (244 cm) from the bottom of the washer.
Floor drain system (view D)
The floor drain system requires a siphon break that may be purchased separately. See “Tools and Parts.”
The siphon break must be a minimum of 28" (71 cm) from the bottom of the washer. Additional hoses might be needed.
To avoid siphoning, no more than 8" (20.3 cm) of drain hose should be below the top of the wash tub. Secure drain hose with beaded tie strap.
39" | 28" |
(71 cm) |
(99 cm)
CD
6