Maytag W10117890A manual Level the Washer, Looped power cord, Install the Front Leveling Feet

Page 9

Looped power cord	Level the Washer
	Properly leveling your washer avoids excessive noise and vibration.
	Install the Front Leveling Feet
	1. Prop up the front of the washer about 4" (10.2 cm) with a wood block or similar object.
	The block needs to support the weight of the washer.

Looped power cord

1. Firmly grasp the yellow shipping strap and pull until both ends are completely removed from washer.

2.Check that two (2) cotter pins were removed with the shipping strap.

(10.2 cm)

A. Threaded holes for feet

2.Screw the locknut onto each foot to within 1" (2.5 cm) of the foot base.

(2.5 cm)

3.Screw the feet into the threaded holes at the front corner of the washer until the nuts touch the washer. Twist the feet to install.

NOTE: Do not tighten the nuts until the washer is level.

4.Tilt the washer back and remove the wood block. Gently lower the washer to the floor.

Image 9

Contents W10117890A AUTOMATIC WASHERUSE & CARE GUIDE WASHER SAFETY TABLE OF CONTENTSINSTALLATION REQUIREMENTS INSTALLATION INSTRUCTIONSWASHER SAFETY Your safety and the safety of others are very importantDANGER SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSTools needed for connecting the drain hose and water inlet hoses INSTALLATION REQUIREMENTSTools and Parts Location RequirementsDrain System Recessed area or closet installationLaundry tub drain system view C Standpipe drain system - wall or floor views A & BGROUNDING INSTRUCTIONS Electrical RequirementsElectrical Shock Hazard Plug into a grounded 3 prong outlet Do not remove ground prong Do not use an adapterStraight power cord INSTALLATION INSTRUCTIONSExcessive Weight Hazard Use two or more people to move and install washerLooped power cord Install the Front Leveling FeetLevel the Washer Connect Drain Hose Steps in Final LocationRemove drain hose from washer cabinet Connect the Inlet Hoses Connecting the drain hose form to the corrugated drain hoseLaundry tub drain or standpipe drain To keep drain water from going back into the washerConnect the inlet hoses to the washer Clear the water linesCheck for leaks A. Cold water inlet valve B. Hot water inlet valveSecure the Drain Hose Complete InstallationStarting Your Washer WASHER USEFire Hazard No washer can completely remove oilWash Temp Temperature GuideSuggested Fabrics WarmWASHER CARE Cleaning Your WasherWater Inlet Hoses Moving and StorageWasher and Components TROUBLESHOOTINGWasher Operation Agitator operationWasher won’t drain or spin Washer ResultsWasher continues to fill or drain cycle seems stuck Wash/Rinse temperature not what I selectedIf you need replacement parts ASSISTANCE OR SERVICELoad is wrinkled Load is tangled or twisted3/07 2007All rights reserved Printed in U.S.A