If your dryer is gas and has a |
| |
full front panel, remove | front | Remove +ccwo |
panel as follows: |
| |
| before opanlng top | |
1.Unplug the power supply cord or turn off the electrical power.
2 Open lint screen lb. Remove two screws from |
|
| ||||
lint screen | area. |
|
|
| ||
3. Open top by pulling forward and up at each |
|
| ||||
front corner (see view A). Rest raised top |
|
| ||||
against wall behind dryer (top is hinged |
|
| ||||
at rear). |
|
|
|
| ||
4. Remove two internal screws from front panel |
|
| ||||
flanges (near top front corners). Lii front panel |
|
| ||||
slightly, lifting off lower dips (see view B). |
|
| ||||
Slowly pull front panel forward, disengaging |
|
| ||||
panel from drum. (Drum will drop slightly.) | Drum 8a1l | Side panel | ||||
6. Move front panel aside and rest edge against | ||||||
|
| |||||
side of dryer. Avoid disconnecting wire clips |
|
| ||||
(see view C) or damaging wires. |
|
| ||||
6. Remove lint from area shown in “gasdryer |
|
| ||||
illustration on page 11 with soft brush or |
|
| ||||
vacuum deaner. Avoid damaging wires, |
|
| ||||
funnel or igniter. |
|
|
| |||
7. Reassemble in reverse order. Before closing |
|
| ||||
the top, check the following: |
|
| ||||
- Drum seal must be flared out (see view D) |
|
| ||||
and properly positioned against panel at |
|
| ||||
bade of drum. Rotate drum countercbck- |
|
| ||||
wise one full turn to chedc drum seal. |
|
| ||||
- Belt should be centered and tight on |
|
| ||||
dryer | drum. |
|
|
| ||
- Wire clips which hold the door switch wires |
| Wlro clip | ||||
must | be | anchored | in slot in top of front |
| ||
panel | (see view C) and along top edge of |
| holds door | |||
side | panel. Door | wires must not touch drum |
| rwltch wires | ||
when dryer is operating. See Warnlng, page 11.
6.Replace top panel and lint screen screws. Top and front panels must be securely in place before operating dryer.
9.Reconnect power and level dryer again (II necessary).
NOTE: Call Consumer Assistance at
12