Electrical requirements
| Electrical shock hazard |
WARNING | Failure to follow these instructions could result in death or serious injury. |
| |
|
|
•Electrical earth is required on this washer
•If it does not fit the outlet, have a proper outlet installed by a qualified electrician.
•Don’t earth to a gas pipe.
•Don’t change the power supply cord plug.
•Check with a qualified electrician if you are not sure the washer is properly earthed.
Recommended earthing method
C
B
A
For your personal safety, this washer must be earthed.
This washer is equipped with a power supply cord ‘A’ having a earthing plug ‘B’. To minimize possible shock hazard, the cord must be plugged into a mating
If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have the proper earthed wall receptacle installed by a qualified electrician.
Drain system
•Never forget to install drain hose before operating your washer.
•Open the packing box, and there is a drain hose inside the drum.
•Connect the drain hose to the drain outlet at the back side of the washer.
•Top of laundry tub must be at least 60cm high and no higher than 100cm from bottom of washer.
•When installing the drain hose to tub(sink), secure it tightly with a string.
•Proper securing of the drain hose will protect the floor from damage due to water leakage.
•When the drain hose is too long, do not force it back into the washer. This will cause abnormal noise.
Level adjustment
1If the washer is installed on an unsuitable
floor, it could make considerable noise, vibrate and cause a malfunction.