Before connection
³Do not connect the AC mains lead until all other connections are complete.
³To prepare the AM loop antenna and speaker cables (and FM antenna for Australia and N.Z.), twist the vinyl tip and pull off ([A]).
1 Flat cables.
Optional antenna connections
Use outdoor antennas if radio reception is poor.
FM outdoor antenna
Note
³Disconnect the FM indoor antenna.
³The antenna should be installed by a competent technician.
Keep the cables as flat as possible against the back of the unit.
Note
Connect the black connectors to the black terminals and the blue connector to the blue terminal. Incorrect connection of the flat cables can damage the unit.
2 FM antenna.
A
FM outdoor antenna
Tuner amplifier
Fix the other end of the antenna where reception is best.
3 AM loop antenna.
1Attach the antenna holder to the rear panel of the CD changer or CD player.
Then clamp the antenna into the antenna holder.
2Connect the antenna terminal to the rear panel of the tuner amplifier.
Keep loose antenna cord away from other wires and cords.
4 Front (L/R) speaker cables.
Connect the cables to the terminals of the same color.
Note
³To prevent damage to circuitry, never
³Be sure to connect only positive (red, blue or gray) wires to positive (i) terminals and negative (black) wires to negative (j) terminals.
5
Surround and center speaker cables.
(For United Kingdom only)
BE SURE TO READ THE CAUTION FOR THE AC MAINS LEAD ON PAGE 4 BEFORE PRO- CEEDING TO STEP 6.
6 AC mains lead.
Insertion of connector
Even when the connector is perfectly inserted, depending on the type of inlet used, the front part of the connector may jut out as shown in the drawing.
However there is no problem using the unit.
Note
The included AC mains lead is for use with this unit only. Do not use it with other equipment.
For your reference:
Information you enter into the unit’s memory, except for time, remains intact for up to two weeks after the mains lead is disconnected.
(For Australia and N.Z.)
A FM ANT 75°
GND
AM ANT
LOOP
EXT
1Remove a piece of the outer vinyl insulator.
30mm
2Twist the shield braid to expose the core wire.
|
|
|
|
| 15mm |
Shield braid | Core wire | ||||
(For others) |
| ||||
A |
| 75 | ° |
| |
|
|
|
|
| |
| FM |
| ANT |
| |
|
|
|
|
| |
| AM | ANT |
| ||
| LOOP | 75 - coaxial cable | |||
| EXT | ||||
| (not included) | ||||
|
|
|
|
| |
(United Kingdom only)
Use the antenna
plug adaptor (included).
AM outdoor antenna
Run a piece of vinyl wire horizontally across a window or other con- venient location.
Note
³Leave the loop antenna connected.
³Disconnect the antenna when the unit is not in use. Do not use the antenna during an electrical storm.
| AM outdoor antenna | |
| ||
Tuner | AM ANT | |
amplifier | LOOP | |
EXT | ||
|
Before use
7
RQT5355