Eagle Electronics Setting Up, Eagle Consus I-SERIES Front and Rear View Disk Installation

2 Setting Up

You will need a 3.5 inch SATA Hard Drive. Carefully follow these procedures to install the hard drive into the enclosure.

Note: For pre-installed Hard Drive EAGLE CONSUS enclosure, please skip this

chapter and proceed to Chapter 3: Connecting the Drive.

EAGLE CONSUS I-SERIES Front and Rear View

Disk Installation

Attention:

Eagle Tech Computers, Inc. is not responsible for consequential damages, including loss or recovery of data from your hard drive. If you are installing with a hard drive that has data inside, we suggest you backup your data before proceeding to installation process.

NOTE: Please skip this section if you are purchasing an Eagle Consus External Hard Drive System with pre-installed Hard Drives. Do NOT attempt to open the external storage system. You will VOID warranty if the warranty seal is damaged.

1. Remove 4 screws from the bottom.

2.Slightly remove the Disk Mounting Try and disconnect the power cable from the socket.

Power Switch – Turns the I-SERIES on or off

Hard Drive access light – Indicates drive activity

Power light – Indicates enclosure is on

RAID Indication – Indicates RAID mode is enabled

USB 2.0 port – Connects to a computer USB port or USB hub

Power supply socket – Connects to power adapter

4 5