TWO STEP
The water inlet is controlled in 2 steps: The first step (1) is with a lesser amount of water, thus the density of the detergent is higher than normal. After washing for a period of time, the second step is activated
(2)and the machine allows the rest of the water in.
For example, the water level was set at 5, the machine may give level 2, for step (1), then the rest of the water level 3, for step (2).
•This function will not be activated when selecting water level 1 or 2, and the DELICATE or BLANKET function.
•When SOAK is selected, this function will not be activated after soaking.
CHILD LOCK
Press the POWER ON/OFF button to switch on the power, and press the WATER LEVEL button for 4 seconds until a sound from the buzzer emits.
To restore, repeat the above or pull out the plug. When CHILD LOCK is set, CHILD LOCK on the control panel lights up indicating E5. If the washer lid is opened during washing the alarm will buzz for approximately 5 seconds.
MULTIPLE WATER POWER
Press the WATER POWER button to adjust the water current during washing or rinsing.
Press it once again, the digital display indicates H0 (standard water power), H1, H2, H3, H4, (stronger, H4 being the strongest); L1, L2, L3, L4 (weaker, L4 being the weakest).
Note: This function cannot be set for the DELICATE or BLANKET modes.
DELETE END OF BUZZER
Press the POWER ON/OFF button to power on the machine.
Press and hold down the START/PAUSE button for 4 seconds until a sound emits from the buzzer. To restore the End Buzzer sound repeat the above steps.
WATER LEVEL
This button allows you to choose the required water level during the WASH/ RINSE process.
How to set the water level:
Press SELECT until the WASH light flashes,
Press the WATER LEVEL button to choose the required water level,
Press the SET button to set the wash time.
Press the SELECT button until the RINSE light flashes,
Press the WATER LEVEL button to choose the required water level,
Press the SET button to set the RINSE times and RINSE type.
Press the SELECT button until the SPIN light flashes,
Press the SET button to set the SPIN time.
Finally press the START/PAUSE button
The machine will start operating according to the set wash water level and rinse water level.
DRAIN RESIDUAL WATER
With this function selected, the drain valve will be opened to drain the residual water 9 minutes after the program has finished.
How to drain residual water:
Press POWER ON/OFF to switch the washer on, hold the PROCESS button for more than 4 seconds until the buzzer sounds.
PAGE 14