Troubleshooting
Problem:
The display states “door”
The display shows F000
The programme takes a long time.
Steam is coming from the dispenser drawer
There is too much foam?
The detergent dispenser will not close properly or is collecting water?
Not all the detergent has been flushed away?
Possible causes / Solution:
●The door is not fully closed, please close fully to start cycle.
●Where 000 is the number (please contact Hotpoint Service and quote the number).
●Check for low water pressure.
●Programme times listed in the Programme Table are approximate. Options selected can affect the programme times (see Programmes and Option Modifiers).
●This is not a fault, we have designed the machine to release steam from the dispenser drawer during hot washes.
●The detergent is not suitable for machine washing:
If you have used the wrong type of detergent, select a Rinse programme to flush out your machine.
●You used too much detergent (see Detergent and Laundry): Refer to the manufacturer’s recommendations.
●Check the drawer is properly aligned.
●Clean the dispenser drawer (see Care and Maintenance).
●Check the cold water supply tap is turned on fully.
●Check the water inlet hoses are not kinked.
●The water pressure is insufficient.
GB
Explained | Wash Labels |
|
|
Contents |
|
|
|
Description |
|
|
|
Option Modifiers | Programmes and |
|
|
Troubleshooting |
|
|
|
Advice | Safety |
|
|
Details | Technical |
|
|
Service |
|
13