About the dryer features. | Hotpoint.com |
Press Guard Option (on some models) |
|
Safety
Use this option to minimize the wrinkles in clothes. It provides approximately
15 minutes of no-heat tumbling after the clothes are dry.
This option can only be used with the COTTONS and WRINKLE FREE cycles.
If you are using the SIGNAL knob and you select the PRESS GUARD option, a signal will sound at the end of the drying time and several times during the PRESS GUARD cycle. This will remind you that it is time to remove the clothes.
If PRESS GUARD is not on, the dryer will stop once the timer reaches the PRESS GUARD mark on the cycle dial.
Instructions
Cycle Signal Option (on some models)
This signal will sound just before the end of the cycle to remind you to remove the clothes. On some models, the signal sound level cannot be adjusted.
If you selected the PRESS GUARD option, the signal will sound at the end of the drying time and will sound several times during the PRESS GUARD cycle. This will remind you that it is time to remove the clothes.
NOTE:
■Remove garments promptly at the sound of the signal. Place clothes on hangers so wrinkles won’t set in.
■Use the Cycle Signal especially when drying fabrics like polyester knits and permanent press. These fabrics should be removed so wrinkles won’t set in.
Operating Instructions
Drum Lamp (on some models)
Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at the household distribution panel by removing the fuse or switching off the circuit breaker. Reach above dryer opening from inside the drum. Remove the bulb and replace with the same size bulb.
7
Troubleshooting Tips