Maintenance and Care
GB | Switching off the electricity | Empty the Water Container after each cycle | |
! Unplug the dryer when not using it, when cleaning it, and | Pull the container out of the dryer and empty it into a sink or | ||
| other suitable drain. Replace container securely. | ||
| during maintenance activities. | Always check and empty the container before you start a new | |
| Clean the filter after each cycle | drying programme. | |
| Cleaning the Condenser Unit | ||
| The filter is an important part of your dryer: it accumulates | ||
| lint and fluff that is formed while drying. | • | Periodically (every month) remove Condenser unit and |
| When finished drying, clean the filter by rinsing it under |
| clean any build up of fluff from between the plates by |
| running water or with your vacuum cleaner. Should the |
| rinsing it under the tap with cold water. This should be |
| filter become clogged up, the airflow inside the dryer will be |
| done with cold water from the rear of the condenser. |
| seriously compromised: drying times lengthen and you will | To remove condenser : | |
| consume more energy. It may also damage your dryer. | 1. Unplug the dryer and open the door. | |
| The filter is found in front of the dryer trim (see diagram). | 2. Pull open the condenser cover (see diagram), release | |
| Removing the filter: |
| the three catches by turning 90° counter clockwise then pull |
| 1. Pull the plastic grip of the |
| on the grip and remove from dryer. |
| filter upwards (see diagram). | 3. Clean the surface of the seals and replace with the | |
| 2. Open the filter by |
| arrows pointing upwards making sure that the catches |
| depressing the clip. |
| have been secured. |
| 3. Clean the lint from the | Cleaning the dryer | |
| inside of the filter, and | ||
| replace it correctly. Ensure | • | External parts in metal or plastic and rubber parts can |
| the filter is fully located flush |
| be cleaned with a damp cloth. |
| into the tumble dryer trim. | • | Periodically (every 6 months) vacuum the front Air intake |
|
|
| grille, to remove any build up of fluff, lint or dust. Also to |
|
|
| remove accumulation of fluff from the front of condenser and |
| ! Do not use dryer without replacing the filter. |
| filter areas, clean occasionally with a vacuum cleaner. |
| ! Do not use solvents or abrasives. | ||
|
| ||
| Check the drum after each cycle | ! | Your dryer uses special bearing components which do not |
|
| need lubrication. | |
| Turn the drum manually in order to remove small items | ! | |
| Have your dryer checked regularly by authorized technicians | ||
| (handkerchiefs) that could have been left behind. |
| to ensure electrical and mechanical safety (see Service). |
|
|
|
Cleaning the drum
!Do not use abrasives, steel wool or stainless steel cleaning agents to clean the drum.
A coloured film may start to appear on the stainless steel drum, this may be caused by a combination of water and, or cleaning agents such as fabric conditioner from the wash. This coloured film will not affect the dryer performance.
Filter
Tap
Rear
Water Contaniner
Condenser
Unit
Condenser | Air Intake |
Unit |
|
Front
Catches
Handle | Condenser Cover |
|
16