Important Information

For your Condenser dryer to operate efficiently, GB you must follow the regular maintenance schedule

shown below:

Fluff Filter – You MUST Clean the fluff filter after every drying cycle.

Step 1

Open the door of your dryer.

Step 2

Pull out the filter (using the two finger grips).

Step 3

Open the filter by releasing the clip.

Step 4

Clean any fluff deposits from the inside surface of the filter mesh.

Step 5

Refit the filter – Never run the dryer without a filter.

Failure to clean the filter after every drying cycle will affect the drying performance of your machine – It will take longer to dry and as a result will use more electricity during drying.

Water Container – You must empty the water container after every drying cycle.

Step 1

Pull the water container towards you and remove it fully from the dryer.

Step 2

Empty the Water from the

Container.

Step 3

Refit the Water Container ensuring that it is pushed fully back into position.

Failure to empty the Water Container will result in:

-The machine will stop heating (so the load may be wet at the end of the cycle).

-The ”Empty Water” light will flash to tell you that the Container is full.

!The water bottle/clean filter light comes on when you select a programme to remind you to make sure that the water bottle is empty and that the filter is

clean before starting a new cycle’

Priming the Water Collection System

When your dryer is new, the Water Container will not collect Water until the system is primed, this will take 1 or 2 drying cycles. Once primed it will collect Water

during every cycle.