Hotpoint manual Start and Programmes, Choosing a programme, Model TVM560, Model TVM562

Page 6

Start and Programmes

GB

Choosing a programme

1.Plug the dryer into the electrical socket.

2.Sort your laundry according to fabric type (see Laundry).

3.Open the door and make sure the filter is clean and in place (see Maintenance).

4.Load the machine and make sure items are not in the way of the door seal. Close the door.

5.Choose a drying time or programme, the way you do this depends on the type of dryer you have:

Model TVM560

Choose a drying time by checking the Drying Guide table for the type of fabric you are drying (see Laundry).

-set the temperature with the HEAT button.

-select a drying time by rotating the TIMER knob clockwise, never counter-clockwise, until the indicator is pointing to the drying time you want.

Model TVM562

Choose a drying programme by checking the Programmes table (see Programmes) as well as the indications for each type of fabric (see Laundry).

-set the temperature with the HEAT button.

-select a programme or drying time by rotating the PROGRAMME knob clockwise, never counter- clockwise, until the indicator is pointing to the drying time or programme you want.

6. (TVM562 only):

-Set a delay time by using the Delay knob if necessary.

-rotate it clockwise until you reach the number of hours you want to delay the start time.

If you have gone too far, turn the knob back counter-clockwise.

7.(TVM562 only) If you wish to eliminate the buzzer sound at the end of the programme, press the ALARM button.

8. Press the START button to begin. (TVM562 only) The ACTIVE indicator light will turn on and will stay on, even during the delay. The indicator light will remain on until you open the door.

During the drying programme, you can check on your laundry and take out the items that are dry, while the others continue drying. When you close the door again, press START in order to resume drying.

9.About 10 minutes before drying is completed, it enters the final COOL TUMBLE phase (fabrics are cooled), this should always be allowed to be completed.

10.(TVM562 only) The buzzer, if ALARM was selected, will warn you when drying is complete.

11.Open the door, take the laundry out, clean the filter and replace it (see Maintenance).

12.Unplug the dryer.

6

Image 6
Contents Instruction booklet Tumble DryerImportant Information Fluff FilterInstallation Where to put your dryerVentilation Before you start using your dryer Electrical connectionsLevelling your dryer Dryer Description Front BackControl panel Model TVM560 Start and ProgrammesChoosing a programme Model TVM562Easy Iron Programme Cool Tumble PhaseProgrammes Table TVM562 only FabricLaundry Sorting your laundryTypical load Special clothing items Drying timesDisposal of old electrical appliances General safetyRecycling and disposal information Saving energy and respecting the environmentMaintenance and Care Following troubleshooting suggestions TroubleshootingProblem Possible causes / Solution Tumble dryer won’t startWhat to tell the Service Centre ServiceBefore calling the Service Centre Spare PartsPage Page Key Contacts