Hotpoint TVM560 Programmes Table TVM562 only, Cool Tumble Phase, Easy Iron Programme, Fabric

Start and Programmes

Programmes Table (TVM562 only)

Programme		What it does...	How to set it...					Note:
	Automatic	Dries completely:	1. Select HIGH HEAT by pressing					! If you select LOW HEAT,
	Drying	your clothes are ready to be		the HEAT button.				this programme will not dry
(average loads)		worn.	2. Position the PROGRAMMES knob					your clothes. For Acrylic
								fibres or small loads select
		For average loads (from 1 to		on	.			Timed Drying.
			3. Press the START button				, the
		3kg) of Cotton, polycotton or
				ACTIVE light will turn on.				This programme can also be
		synthetics.
								used for large loads if you
								require a slightly drier result.
	Automatic	Dries completely:	1.	Select HIGH HEAT				! If you select LOW HEAT,
	Drying	your clothes are ready to be						this programme will not dry
				by pressing the HEAT button.
(large loads)								your clothes. For Acrylic
		worn.	2.	Position the PROGRAMMES knob
								fibres or small loads select
		For large loads (from 3 to 6kg) of		on		.		Timed Drying.
		Cotton.	3.	Press the START button			, the	This programme can also be
				ACTIVE light will turn on.
								used for average loads if you
								prefer a damper result.
	Easy Iron	Brief programme (approximately	1.	Select HIGH HEAT by pressing				! This is not a drying
		10 minutes) that softens fibres of		the HEAT button.				programme (see below).
		clothing that is ready for ironing.	2.	Position the PROGRAMMES knob
				on	.
			3.	Press the START button			, the
				ACTIVE light will turn on.
Timed Drying		Dries wet clothes that will be	1.	Select required heat setting HIGH				Consult suggested drying
(up to 120 minutes)		ironed, Acrylic fibres, or small		HEAT or LOW HEAT by pressing				times (see Laundry).
		loads (less than 1kg).		the HEAT button.
		If you prefer a timed programme	2.	Position the PROGRAMMES knob
		can be used for other fabrics on		on the desired time.
		HIGH or LOW heat as appropriate	3.	Press the START button			, the
		(see Laundry).		ACTIVE light will turn on.
	Cool Tumble	Use to refresh fibres of clothing	1. Position the PROGRAMMES knob					! This is not a drying
		(approximately 10 minutes).		on	.			programme (see below).
			2. Press the START button				, the
				ACTIVE light will turn on.

Cool Tumble Phase

This is the programmes’ final phase. Approximately 10 minutes before the finish, the knob advances automatically to the Cool Tumble Phase. Heating elements turn themselves off and clothing is cooled down, after this the Buzzer will sound (if selected) and the clothing is ready to be taken out.

!Always allow the dryer to complete this phase.

Easy Iron Programme

‘Easy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The cycle relaxes the fibres and makes them easier to iron and fold.

!‘Easy Iron’ is not a drying programme and should not be used for wet articles of clothing.

For best results:

1.Do not load more than the maximum capacity. These numbers refer to the dry weight:

Fabric	Maximum load
Cotton and Cotton mixtures	2.5kg
Synthetics	2kg
Denim	2kg

2.Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put them away in the closet. Should this not be possible repeat the programme.

The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton mix, and less well on acrylic fibres and on materials such as Tencel®.

GB

Information	Important
Installation
Description
Programmes	Startand
Laundry
Suggestions	Warningsand
andCare	Maintenance
Troubleshooting
Service

7