Hotpoint THDP 871 Dryer Description, To open the door, Features, Control panel, Display Unit

Page 8

Dryer Description

GB

To open the door

Press and release the front panel in position shown

Heat Pump

Filter Unit (cover open)

Adjustable Feet

The features

Water container Rating plate

Model & Serial numbers

Heat Pump

 

 

 

 

 

Air intake

 

 

 

 

 

 

 

 

Filter cover

 

 

 

grille

Heat Pump Filter cover

 

Filter

handle (Pull to open)

 

 

 

 

Control panel

PROGRAMME

Selection Buttons

ON/OFF

Button

Display Unit

CHILD LOCK & OPTIONS

Buttons & Lights

START/PAUSE

Button & Light

The ON/OFF button - if pressed when the dryer is running: If the display shows TURNING OFF the dryer stops. If the display shows PRESS AND HOLD hold the botton and the display counts down 3, 2, 1 and then stops.

Press and hold again for more than 3 seconds, the display briefly shows POWER ON .

The PROGRAMME selection buttons set the programme: press the button corresponding to the programme you want to select (see Start and Programmes).

The OPTION buttons/indicators: these buttons select available options for your selected programme (see The Controls). The indicators on the display unit next to the bottom buttons light to show that the option has been selected.

The START/PAUSE button/light starts a selected programme. When you press this button there will be one beep and the display will show PAUSE . When a programme is running, holding this button in pauses the programme and stops the dryer.

The light is green when the programme is running, flashing amber if the programme has been paused or

flashing green if on standby waiting to start a programme (see Start and Programmes).

Note: This light also flashes amber during the Post Care phase of a programme.

The Display Unit gives warnings and information about the programme selected and its progress (see next page).

The CHILD LOCK button/icon : Press and hold this button after selecting your programme and any options, this prevents the programme settings from being changed, the display will briefly show LOCKED . When the icon is lit, the other buttons are disabled. Hold the button to cancel and the icon will go out, the display will briefly show UNLOCKED .

Note: This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press and hold the ON-OFF button until the display briefly shows POWER ON and the dryer then reactivates.

8

Image 8
Contents Contents Instruction bookletInstallation Where to put your dryerVentilation Water drainElectrical connections Before you start using your dryer Maximum loadGeneral safety Page Maintenance and Care Switching off the electricityClean the filter after each cycle Empty the water container after each cycleCheck the drum after each cycle Cleaning the drumCleaning the dryer Features Dryer DescriptionTo open the door Control panelDisplay Selecting your languageUnderstanding the display Dryness levelsDelay and Time to End Programme progressTimed drying Time to EndMy Cycle button Start and ProgrammesChoosing a programme Programmes Table Wool Programme DelicatesEasy Iron Programme FabricControls Option buttonsLaundry Sorting your laundry Drying timesMaximum load size Wash Care LabelsPossible causes / Solution TroubleshootingProblem Service Before calling the Service CentreHeat Pump System Spare PartsRecycling and Disposal Information Disposal of old electrical appliancesPage 5 1 2 1 1 8 4 0 N