Dryer Description
The features
Rating plate
Filter
Condenser cover
Water container
Model & Serial numbers
Condenser cover handle (Pull to open)
Air intake grille
GB
Information | Important |
Installation |
|
Description |
|
Control panel
Indicator |
|
|
| ||
PROGRAMME |
|
| CHILD LOCK |
| HEAT LEVEL |
| |||||
knob |
|
| Button & Light |
| Button & Lights |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Display Unit & |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
ON/OFF |
| Selection Buttons |
| OPTION |
|
| START/PAUSE | |
|
| |||||||
Button |
| Buttons & Lights |
|
| Button & Light | |||
| ||||||||
|
|
| ||||||
The Display |
|
Start and Programmes |
|
Laundry |
The ON/OFF button 
: If the dryer is running and this button is pressed and held for more that 3 seconds the dryer is turned off, it counts down 3, 2, 1, Off and the programme is then cancelled.
Press and hold for more than 3 seconds and the dryer reactivates.
The PROGRAMMES knob sets the programme: rotate it until the indicator is pointing to the programme you want to select (see Start and Programmes).
The OPTION buttons select available options for your selected programme. The lights indicate that the option has been selected (see Start and Programmes).
The START/PAUSE button/light 
starts a selected programme. When you press this button there will be one beep and the progress lights will flash to confirm the action. When a programme is running, holding this button in pauses the programme and stops the dryer.
The light is green when programme is running, flashing amber if the programme has been paused or flashing green if on standby waiting to start a programme (see Start and Programmes).
The Display Unit gives an indication of the drying or delay time together with icons that light to give warning information and show the status of your programmes progress.
The three buttons below the display select ‘Automatic’ or ‘Timed Dry’ and if required a delayed start (see Start and Programmes or The Display).
The CHILD LOCK button/light 
: Press and hold this button after selecting your programme and any options, the light turns on. This prevents the programme settings from being changed. When the light is lit, the other buttons are disabled. Hold the button to cancel and the light will go out.
The Empty Water icon 
: signals that the water container should be emptied. The display will take a few seconds to update after replacing the empty water container, the dryer must be running for this to happen (see The Controls).
Note: If the water container fills the ‘water container full ‘icon
flashes, the display shows 
, the heat is turned off and your clothes will not dry.
The Clean Filter icon 
: gives a reminder before every programme, that it is essential to clean the filter every time the dryer is used (see Maintenance and Care).
The Clean Condenser icon 
: gives a reminder that it is essential to clean the condenser at regular intervals (see Maintenance and Care).
Suggestions | Warnings and |
|
|
and Care | Maintenance |
|
|
Troubleshooting |
|
Service |
|
5