Spray Function

Obtain more steam (according to model)

• Press the Superpressing	button	now and again to remove Wait a few seconds
stubborn creases (fig 7).		between each shot before
		pressing the button again.

•Whether steam or dry ironing, you are able to use the Spray button (fig 8) to dampen laundry to remove stubborn creases.

Vertical steam ironing (according to model)

Ideal for removing creases in suits, jackets, skirts, curtains, etc. :

•Hang the garment on a hanger and hold the fabric slightly taut with one hand.

•Set the thermostat control to MAX (fig 9).

•Press the Superpressing button repeatedly (fig 7) moving the iron from top to bottom (fig 10).

•Hold the iron a few centimetres from the fabric to avoid burning delicate fabrics.

Every fifth time you press the button, return the iron to the horizontal position. The steam is very hot, so you should always do this with the garment on a hanger – never while someone is wearing it.

Store your iron

•Set the steam control to and unplug the iron.

•Wait until the soleplate cools down and empty the reservoir. A little water may remain in the reservoir.

•Wind the cord around the heel of the iron.

•Store the cold iron on its heel (fig 11).

Maintenance and cleaning

Cleaning the anti-calc valve (once a month)

•Unplug your iron and empty the water tank.

•Press the self-cleanejection button (fig 12a) and remove the anti-calc cartridge (fig 12b)

•Soak the valve in a cup of white spirit vinegar or plain lemon juice for 4 hours.

•Rinse the valve under running water and Replace the anti-calc valve.

Unplug your iron and let it cool down before clean- ing it.

The iron will not function without the anti-calc valve. Never touch the end of the valve !

Carry out the self-cleaning operation (once a month)

To slow down scaling and prolong the useful life of your iron, carry out the self-cleaning operation once a month.

•Unplug your iron, set the steam control to and fill the water reservoir to MAX.

•Place your iron on its heel, set the thermostat button to MAX, plug in your iron and wait for the indicator light to go out.

•Unplug the iron and place it horizontally over a sink.

•Press the self-clean ejection button (fig 12a) and remove the anticalc cartridge (fig 12b).

•Gently shake the iron over the sink until some of the water (along with impurities) runs out through the soleplate.

•At the end of the operation, put the anticalc cartridge back in place and then plug in your iron for 2 minutes on its heel to dry the soleplate.