TROUBLE SHOOTING
Most problems are easily solved if you understand the cause. Check the following list for problem before calling for service.
If error mode such as IE, OE, UE were displayed on the control part, in this case, how to solve these problem is first open and close the door, and then press START/PAUSE button.
PROBLEM | CHECK POINT |
|
|
• The washer will not | • Is there a power failure? |
operate at all. | • Is the power cord correctly connected to an electric outlet? |
| • Did you turn on the power? |
| • Did you press Start/Hold button? |
| • Is there correct amount of laundry in the washer. |
• Water is not supplied | • Did you connect the inlet hose and open the water tap? | ||
Error display |
|
| • Is the inlet hose or the water tap frozen? |
| |||
•Is the water supply shot off?
•Is there any foreign matter blocking up the inlet hose filter?
• The washer will not drain | • Is the drain hose frozen or blocked up by dirt? | ||
Error display |
|
| • Is the drain hose kinked or deformed? |
| |||
•Is the end of the drain hose immersed in water?
•Is there excessive dirt inside the drain filter?
| • The washer will not spin | • Is the clothes in the drum collected on one side? | |||
|
|
|
| • Is the washer installed on an uneven floor or is the vibration | |
| Error display |
|
| ||
|
|
| |||
|
|
| serious? | ||
|
|
|
| ||
|
|
|
| ||
|
|
|
| • Is the door open? (The lamp “ | will” light up in this case.) |
|
|
| |||
| • Vibrating and too noisy | • Is the washer installed on an uneven floor? | |||
|
|
|
| • Have all the transit bolts removed? | |
Note
• If 
and 
error mode are showed on PCB board, please contact service center.
These cases are not malfunctions;
•The sound “wing” heard during water supply is the operating sound made by the water inlet valve.
•The sound “sha” heard in stopping the tub is the sound that comes from the autobalbancer of the tub.
30