Washing Procedure and Selection

1. NORMAL PROGRAM

Put the laundry into the Drum and put the detergent and softerner into the detergent case.

Then close the Door.

•Put the detergent into the main wash room(I I marking) and prewash room(I marking)

1in the detergent case.

•Softener should be below 'MAX' level.

•Put the detergent into the pre wash room(I marking) only if you want to add prewash.

•When you want to use bleach, put it into the main wash room (I I marking) with detergent.

	2	Press the Power button.
		• The LED shows only '- --' signal.


		Select the 'NORMAL' program using the program selection dial.
		• If you press 'Start/Pause' button aftrer pressing Power button without selecting
		program, the 'NORMAL' program is selected as default program.
	3	• Main wash' and '3' times rinse and '800' rpm spin speed and°C''40water temperature
		are selected automatically.

		• If you want to change the 'Washing course' and 'Rinse time(s)' and 'Spin speed' and
		'water temperature', select program what you want to change by pressing each
		button.

Press the 'Start/Pause' button.

4• The washer will be operated with locking Door and supplying water after sensing the amount of laundry automatically.

Note

•If you want to change the setting program during operation, press the 'Start/Pause' button to hold the operation and change the program you want to change by pressing each corresponding button.

•Water temperature '95°C' is not selected in order to prevent clothes from damaging.

•If you want to add the clothes during operation, press 'Start/Pause' button and 'Door unlock' button, then open the Door and put the clothes into the Drum and then close Door and press 'Start/Pause' button again.