Electrolux EW 1000 I manual Unpacking, Installation on a Suspended Floor

Page 22

Unpacking

All transit bolts and packing must be removed before using the appliance.

You are advised to keep all the packaging for re-use in case the machine is to be transported again.

Set the machine upright and remove the two remaining bolts from the back.

Pull out the three plastic spacers from the holes into which the bolts were fitted.

Plug the open holes with the plugs supplied with the instruction bookleet.

Using a spanner unscrew and remove the rear right bolt. Lay the machine gently on its back, making sure that the hoses are not squashed.

P0256

Positioning

P0020

Remove the polystyrene base and take off the bottom panel by unscrewing the central screw. Carefully slide out the right polythene bag.

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.

Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the

P0457

P0015

floor.

Your new washing machine has been designed to be permanently plumbed in to your home’s water supply and drainage system. However, if this is not possible, it may be connected to suitable existing taps with the drain hose discharging into a sink.

The appliance has two inlet hoses, hot and cold, with female 3/4” BSP thread connectors. If this connection is not compatible with the plumbing of the existing

Repeat the operation for the left and central polythene bags.

Re-fit the bottom panel using the 4 screws supplied with the door hinges (in the plastic bag) and the previously removed screw.

installation, a variety of connectors are available from good hardware stores and plumbers merchants to suit most domestic plumbing. Any alteration to your existing plumbing must be carried out by a competent person, or qualified plumber.

P0016

P0453

Installation on a Suspended Floor

Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws. If possible install the appliance in one of the corners of the room, where the floor is more stable.

22

Image 22
Contents Instruction Booklet InstallationUse Child SafetyContents Ecological hints Your New Washing MachineInterest Environment Description of the Appliance Detergent dispenser drawerControl Panel Operating Sequence Start the machine At the end of the programmeWashing 2 KG of Mixed Fabrics AT 50C At the end of the programme Washing Hints 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesType of laundry Washing ProgrammesOptions Load Programmes for synthetics, mixed fabrics, delicates and wool Maintenance and Cleaning Water inlet filters Something Not Working 0870 5 Service & Spare PartsSymptom Possible causes Customer CareEuropean guarantee Guarantee ConditionsStandard guarantee conditions This guarantee does not coverInstallation Instructions Technical SpecificationsInstallation on a Suspended Floor UnpackingWater inlet Water drainageSpecial conditions LevellingInterest of the environment Electrical connection Permanent connectionPreparation and assembly of the door Building-inFront view Electrolux Group. The world’s No choice