Electrolux EW 1000 I manual Water inlet, Water drainage

Page 23

Water inlet

The inlets on the back of the appliance are colour coded, blue for cold and red for hot.

Connect the hoase to a tap with a 3/4” thread.

P1088

If only a cold water supply is available, connect the two hoses to a cold water outlet by means of a «Y» connection piece.

Installation should comply with local water authority and building regulations’ requirements.

The appliance must be given a separate cold water supply and not be connected to a mixer tap, a single outlet water heater or a booster pump. A minimum water pressure of 0.48 bar is required for safe operation of the appliance.

If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum distance of 5.02m

(16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

There will be sufficient pressure for the hot water supply, providing there is a minimun height of 2.74 metres (9 ft) between the bottom of the cold water storage tank and the bottom of the hot water cylinder.

Set the hoses correctly by loosening the ring nuts. After positioning the inlet hoses, be sure to tighten the ring nuts again to prevent leaks.

P0021

Water drainage

This appliance is designed to be permanently plumbed into your home's water supply and drainage system.

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece” supplied.

(12")cm

30

P1074

The standpipe should have an internal diameter of approximately 38mm (see diagram) thus ensuring there is an air break between the drain hose and standpipe.

 

38 mm.(1/2") diameter

cm.(12")30Min.

1

standpipe

 

P1040

When discharging into a standpipe ensure that the top of the curve in the hose end is no more than 90cm (35.4'') and no less than 60cm (23.6'') above floor level. The upright standpipe should have a minimum length of 30cm (12'') from the bottom of the elbow to the top of the pipe (see diagram).

Make sure that it is designed in such a way, that the end of the drain hose cannot be covered with water.

3 pin

 

90 cm.(35.4")

cm.

Max.

Min.60 (23.6")

P1039

 

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18mm.

23

Image 23
Contents Instruction Booklet Child Safety InstallationUseContents Interest Environment Your New Washing MachineEcological hints Detergent dispenser drawer Description of the ApplianceControl Panel Operating Sequence At the end of the programme Start the machineWashing 2 KG of Mixed Fabrics AT 50C At the end of the programme 1000g = 1 kg Washing HintsWhich form? Which detergent?Important Notes Wash Care SymbolsOptions Load Washing ProgrammesType of laundry Programmes for synthetics, mixed fabrics, delicates and wool Maintenance and Cleaning Water inlet filters Something Not Working Customer Care Service & Spare PartsSymptom Possible causes 0870 5This guarantee does not cover Guarantee ConditionsStandard guarantee conditions European guaranteeTechnical Specifications Installation InstructionsUnpacking Installation on a Suspended FloorWater drainage Water inletInterest of the environment LevellingSpecial conditions Permanent connection Electrical connectionBuilding-in Preparation and assembly of the doorFront view Electrolux Group. The world’s No choice