Installation
Transit security bars
Before starting the machine up, the transport security bars must be removed as follows:
You are advised to keep all the transport security bars. In case the appliance has to be transported again.
1.Unscrew and remove the three rear screws by means of a key.
2.Open the porthole, and remove the polystyrene block fitted with the adhesive tape on the door seal.
3.Place the machine in an upright position and remove the three plastic bolts.
4.Plug the 3 holes with the plastic plugs which you can find in the envelope containing the instruction booklet.
installation 55
Hydraulic connection
There should be a COLD WATER tap near the washing machine with a screwing on connection pipe of 3/4 gas for the water supply, a sink, a wash basin or a drainage system in the wall.
Previously check if:
-it is not a hot water tap.
-the running water is clean. If not, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.
Have the permanent drainage system in the wall checked by a plumber.
P1090 |
1.Carefully screw the pipe to the tap taking care not to damage the screwdrive and fix the nut well on to the end in order to avoid leaking.
P0021 |
2.If necessary turn the hose adequately by unscrewing the nut at the rear of the appliance. Now tighten the nut anew to avoid leaks. (Open the tap and assure that it does not leak and close it again.)