Service

Problem	Possible cause	Possible solution
You cannot open	The washing programme	Let the washing programme end.
the appliance	is in operation.
door.

There is water in the drum.

Set the drain or the spin pro- gramme.

The appliance	Incorrect level of the ap-	Adjust the level of the appliance.
makes an unusual	pliance.	Refer to 'Installation'.
noise.
	You did not remove the	Remove the packaging and/or
	packaging and/or the	the transit bolts. Refer to 'Instal-
	transit bolts.	lation'.
	The load is very small.	Add more laundry in the drum.
The appliance fills	The end of the drain	Make sure that the drain hose is
with water and	hose is too low.	in the correct position.
drain immediately.
The washing re-	The detergent you used	Increase the detergent quantity
sults are not satis-	was not sufficient or cor-	or use a different one.
factory.	rect.

You did not remove the stubborn stains before you wash the laundry.

Use special products to remove the stubborn stains.

Incorrect temperature	Make sure that you set the cor-
was set.	rect temperature.
Too much laundry load.	Decrease the laundry load.

After the check, activate the appliance. The programme continues from the point of interruption.

If the problem occurs again, contact the service centre.

If the display shows other alarm codes, contact the service centre.

• Refer to the information supplied with this appliance for guarantee condition and point of contact. The information to give to the service is on the rating plate.

We recommend that you write the in- formation here:

Model..................

(MOD.)

Product number ..................

(PNC)

Serial number..................

(S.N.)

Problem

SERVICE