Electrolux 137356900 A manual Install Cycle, Reset

Page 30

30Operating User Interface Features

Setting Preferences, continued

INSTALL CYCLE

Run the INSTALL CYCLE before operating the wash- er the first time. Remove all items from the washer drum and press start. For more information on performing the washer INSTALL CYCLE, refer to the Installation Instructions accompanying this washer.

If the washer has been installed according to Installation Instructions, INSTALL PASSED - DOOR CAN BE OPENED will be displayed and the washer

is ready to use.

If the washer was not installed properly, NO WATER -

OPEN WATER VALVES, WATER HOSES - CHECK WATER HOSES or CALL SERVICE 877 435 3287

will be displayed to indicate the installation error.

The errors may result from the following conditions:

•NO WATER —Water inlet hoses have not been at- tached to water supply or water supply valves have not been turned on. Install hoses correctly and turn on water supply valves.

•CHECK HOSES —The hot inlet hose may have been connected to the cold water supply and the cold inlet hose may have been connected to the hot water supply. Check hoses for correct sup- ply connection. If incorrect, disconnect hoses and connect to correct inlets according to Installation Instructions.

•CALL SERVICE 877 435 3287—Error can only be corrected by calling a qualified technician (1- 877-435-3287).

Repeat the INSTALL CYCLE when corrections are completed.

RESET

Press the buttons indicated to restore only cycle set- tings, reset only factory preferences (users, language, brightness, volume, etc.) or restore all factory defaults (both cycle settings and factory preferences). Press the button under EXIT to return to normal operation or press the cancel button to turn the washer off without making any changes. If you do not make a selection within 30 seconds the washer will return to normal operation without any changes. If you reset all settings, INSTALL CYCLE will be displayed as though the washer were just turned on for the first time. You may press the button under CANCEL if you do not wish to rerun the INSTALL CYCLE.

NOTE

The INSTALL CYCLE is prompted automatically only once when the washer is turned on the first time at the end of installation. After that,

if you wish to run a subsequent INSTALL CYCLE when moving the washer or modifying your installation, you may perform your own INSTALL CYCLE by selecting it in the set prefs feature and then following the screen prompts.

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Use & Care Guide Please read and save this guide Table of contentsFinding Information Keep a record for quick referenceSafety Important Safety InstructionsRecognize safety symbols, words Labels Prevent Fire Protect ChildrenPrevent Injury Prevent Injury and Damage to the WasherFeatures Normal Operating Sounds Operating InstructionsGetting Started To run your washer, follow these basic stepsOperating Your Washer Before Using Your WasherOperating Your Washer Sort laundry into loads that can be washed togetherOperating Your WASHER, 3. Pretreat stains and heavy soil Add laundry load to washerFor best results Operating Your Washer Other Wash ProductsTemperature Operating Your Washer Start the washer Entrapment and TIP-OVER HazardWhites Cycle SelectionNormal Heavy DutyActive Wear Deep Clean SanitizeCasual Fast WashSpecialty Cycles JeansFast Sanitize Specialty Cycles MY Favorites MY Favorites ModeWashing/Rinsing Temperature Temperature Spin Speed Soil LevelOptions ADD SteamExtended Fresh ECO FriendlyAllergen Shrink GuardDelay Start Warm RinseWasher Settings Chart Operating User Interface Features User Interface FeaturesSaving Favorites Setting Preferences Custom ModeInstall Cycle ResetBrightness VolumeContrast LanguageDrum Light Other FeaturesStatus Display Reversible DoorStain Removal Guide Stain Removal ProceduresSafe Stain Removal Procedures For Successful Stain RemovalStain Removal Suggestions Stain TreatmentCare & Cleaning Inside Routine Cleaning PreventativeTo Refresh or Clean Inside of Washer Other Inside Routine Cleaning Preventative Cleaning Dispenser Drawer AreaDaily Preventative Maintenance Inside Cleaning Aggressive Cleaning Procedure Washer DrumOutside Routine Cleaning Winterizing InstructionsSolutions to Common Problems Common Washing ProblemsDo not use chlorine bleach to re Service Prevention Checklist Occurrence Possible Cause SolutionAvoid Service Checklist WaterWarranty Information Exclusions
Top Page Image Contents