40Solutions to Common Problems
Common Washing Problems, continued
PROBLEM | POSSIBLE CAUSES | SOLUTIONS | PREVENTIVE MEASURES | ||
|
|
|
|
|
|
Yellow | • Agitation time too short. | • | Soak in detergent booster or | • | Select correct wash cycle. |
buildup of | • Wash water temperature too |
| product containing enzymes. | • | Use correct amount of |
body soil | low. | • | Wash in hottest water safe for |
| detergent. |
on synthetic | • Not enough detergent. |
| fabric using casual cycle. | • | Wash synthetics frequently |
fabrics |
| • Increase detergent. |
| using hot or warm water. | |
|
| • Add bleach safe for fabric or |
|
| |
|
|
| treat with color remover. |
|
|
|
|
|
|
| |
Yellow or | • Iron or manganese in water | • To restore discolored load of | • | Use nonprecipitating water | |
brown rust | supply, water pipes, or wa- |
| whites, use rust remover safe for |
| softener. |
stains | ter heater. |
| fabric. | • Before washing, run hot water | |
|
| • | Do not use chlorine bleach to re- |
| for a few minutes to clear lines. |
|
|
| move rust stains. It may intensify | • | Drain water heater occasionally. |
|
|
| discoloration. | • | For an ongoing problem, |
|
|
|
|
| install an iron filter in your |
|
|
|
|
| water supply system. |
|
|
|
| ||
Residue | • Moisture in the washer. | • Perform CLEAN WASHER cycle | • Run dehumidifier in laundry | ||
stains / build- | • Use of | • Scrub gasket with Comet™ |
| room. | |
up, mold or | • Overdosing detergent. |
| Spray Gel Mildew Stain Remover | • | Avoid overfilling detergent |
mildew stains | • Overloading wash drum. |
| using brush to remove stains. |
| and fabric softener com- |
in gasket | • Leaving a wet load set in | • Use only HE (high efficiency |
| partments of dispenser. | |
| washer. |
| detergent) along with recom- | • | Dry the inside of washer |
| • Cold water washes which |
| mended dosage. |
| and gasket after every run. |
| may not completely dissolve | • Remove wash load immediately |
|
| |
| and remove detergents. |
| upon cycle completion. |
|
|
|
|
|
|
| |
Residue | • Moisture in the washer. | • Remove dispenser drawer and | • | Avoid overfilling detergent | |
stains / build- | • Use of |
| wipe dispenser and inserts with |
| and fabric softener com- |
up, mold or | • Overdosing detergent. |
| combination of ¾ cup liquid |
| partments of dispenser. |
mildew stains |
|
| chlorine bleach and one gallon |
|
|
in dispenser |
|
| hot water. Rinse well, and repeat |
|
|
drawer |
|
| if necessary. Return drawer to |
|
|
|
|
| location. NOTE: Wear rubber of |
|
|
|
|
| latex gloves. Protect floor and |
|
|
|
|
| clothing from bleach damage. |
|
|
|
| • Use only HE (high efficiency |
|
| |
|
|
| detergent) along with recom- |
|
|
|
|
| mended dosage. |
|
|
|
|
|
|
| |
Water in fold | • Result of washing and part | • At the end of each wash, dry |
|
| |
of flexible | of normal operation. |
| inside of gasket fold with clean |
|
|
gasket |
|
| dry towel all around gasket. |
|
|
|
|
|
| ||
Odor | • Moisture in the washer. | • Perform CLEAN WASHER cycle. | • Leave door and dispenser | ||
| • Use of | • At the end of each wash, dry |
| drawer open for a few | |
| • Overdosing detergent. |
| inside of gasket fold with clean, |
| hours after use or whenever |
| • Leaving a wet load remain in |
| dry towel all around gasket. |
| washer is not in use. |
| washer. | • Use only HE (high efficiency |
|
| |
| • Cold water washes which |
| detergent) along with recom- |
|
|
| may not completely dissolve |
| mended dosage. |
|
|
| and remove detergents. | • Remove wash load immediately |
|
| |
|
|
| upon cycle completion. |
|
|
|
| • Pour one cup liquid chlorine |
|
| |
|
|
| bleach in standpipe; let remain a |
|
|
|
|
| day and flush with water. |
|
|
|
|
|
|
|
|