10Installation Instructions
Connecting inlet water
1.Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog the water valve screens and to determine which faucet is hot and which is cold supply.
2.Look in the end of each water supply inlet hose and verify that the rubber washers are in place.
RUBBER WASHERS
MUST BE PRESENT
NOTE
HOT and COLD water inlet hoses are color coded for identification. The HOT inlet hose is marked with a RED band and the COLD inlet hose is marked with a BLUE band.
3.Connect the HOT inlet hose to the HOT water supply and the COLD inlet hose to the COLD water supply. Tighten by hand until snug.
4.Tighten each supply connection another 2/3 turn with pliers.
5.Turn on the water and check for leaks.