Electrolux 137098000 Removing Striker Plate, Removing Latch Indicator, Removing Hole Plug

Page 16

G)Removing Striker Plate

1Remove 2 long, course-thread, counter-sunk screws and striker plate.

2Set the striker plate to the side for later.

1Insert flat blade screwdriver into open slot of latch indicator.

2 Gently pry upward to release tab.

3 Pull the indicator out and set it aside.

1Insert flat blade screwdriver into open slot of hole plug.

2 Gently pry upward to release tab.

3 Pull the hole plug out and set it aside.

Image 16

Contents Installation Instructions Table of contents Finding InformationPlease read and save this guide Keep a record for quick referenceImportant Safety Instructions SafetyPre-installation requirements Installation Requirements Electrical system requirementsGrounding requirements Water supply requirementsDo not Install Your Washer Clearance requirementsInstalled washer dimensions Unpacking Washer Removing foam packagingInstalling hole plugs Removing shipping hardwareInstallation Instructions Leveling your washerConnecting inlet water Rubber Washers Must be PresentConnecting drain and electrical Performing Installation Cycle Reversing Door Preparing to reverse door swingRemoving door and hardware Removing Trim RingRemoving Hinge from Front Panel Removing Door Lock from Front PanelReattaching Door Lock to Front Panel Reversing door and hardwareReattaching Hinge to Front Panel Removing Striker Plate Removing Latch IndicatorRemoving Hole Plug Reattaching Striker Plate Reinserting Latch IndicatorReinserting Hole Plug Reattaching door and hardware Replacement parts 1-877-4ELECTROLUX AccessoriesOptions