Removing accumulated
Lint can gather inside the dryer and be a fuel for fire. Lint should be removed every two to three years, or more often, depending on dryer usage. Cleaning should be done by a qualified person. If you have any questions or comments, please call our Consumer Assistance Center at
For all electric dryers, or gas dryers
1.Unplug the power supply cord or turn off the electrical power.
2.Electric dryers:
Remove back panel using a
Gas dryers:
Pry off lower front access panel using a
3.Remove lint from shaded area in illustra- tion with a soft brush or vacuum cleaner. Avoid damaging wires, thermostats (electric), funnel (gas), or ignitor (gas).
4.Replace panel.
5.Reconnect and level dryer again, if necessary.
lint
Electrical Shock Hazard
Unplug the power supply cord or turn off the electrical power before removing dryer panels.
Make sure the dryer is cool.
Dryer parts can have sharp edges. Use care when handling.
When replacing front panel after lint removal, the wire clips holding the door switch wires must be anchored to top of front and side panels. Wires MUST NOT touch rotating drum.
Failure to do so could result in electrical shock or personal injury.
Thermostats Heater Heat element
box terminals
Electric dryer with back panel removed
lgnitor Funnel
Gas dryer with lower front access panel removed
12