Whirlpool RGX3514PQ0 warranty Checking Your Vent, What to do if YOU Smell GAS

Page 3

WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, or to prevent property damage, personal injury, or death.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Clear the room, building, or area of all occupants.

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

Checking Your Vent

Your dryer must be properly installed and vented to achieve maximum drying efficiency and shorten drying times. Use the minimum recommended installation clearances found in your Installation Instructions. See the Installation Instructions for more information.

WARNING

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death or fire.

If the dryer is not properly installed and vented, it will not be covered under the warranty.

NOTE: Service calls caused by improper venting will be paid for by the customer, whether it was a paid installation or self- installed.

1.Do not use plastic vent or metal foil vent. Use 4" (10.2 cm) metal or flexible metal vent. Do not kink or crush flexible metal vent. It must be completely extended to allow adequate exhaust air to flow. Check vent after installation. Refer to your Installation Instructions for proper length requirements of vent.

2.Use a 4" (10.2 cm) exhaust hood.

3.Use the straightest path possible when routing the vent.

4.Use clamps to seal all joints. Do not use duct tape, screws or other fastening devices that extend into the interior of the vent to secure vent.

5.Clean exhaust vent periodically, depending on use, but at least every 2 years, or when installing your dryer in a new location. When cleaning is complete, be sure to follow the Installation Instructions supplied with your dryer for final product check.

3

Image 3
Contents Instructions Pour L’UTILISATEUR DE LA Sécheuse Dryer User InstructionsYour safety and the safety of others are very important Dryer SafetyWhat to do if YOU Smell GAS Checking Your VentHeavy Work Clothes Mixed Load Towels Delicates Dryer USELoading Starting Your DryerDryer Care Cleaning the Dryer LocationCleaning the Lint Screen Cleaning the Dryer InteriorDryer Operation TroubleshootingRemoving Accumulated Lint Changing the Drum LightGarment damage Roper Dryer WarrantyLoads are wrinkled OdorsSécurité DE LA Sécheuse Assistance ou serviceQUE Faire Dans LE CAS D’UNE Odeur DE GAZ Chargement La sécheuse doit être bien installée et munie d’un systèmeUtilisation DE LA Sécheuse Vérification du conduit d’évacuationPour arrêter la sécheuse Mise en marche de la sécheuseOption grille de séchage Arrêt et remise en marcheNettoyage de l’intérieur de la Sécheuse Nettoyage de l’emplacement de la SécheuseEntretien DE LA Sécheuse Nettoyage du filtre à charpieDépannage Comment enlever la charpie AccumuléeChangement de l’ampoule du Tambour Charges avec faux plis Charpie sur la chargeTaches sur la charge ou décoloration Rétrécissement des articlesTéléphoner au Centre dinteraction avec la clientèle au Garantie DE LA Sécheuse RoperWhirlpool Corporation ne paiera pas pour Pour localiser des pièces de rechange FSP dans votre régionWhirlpool Corporation All rights reserved