Whirlpool REL3612BW2 warranty Remove screws before opening top ’ View a View B

Page 15

If your dryer is gas and has a full front panel, remove front panel as follows:

1.Unplug the power supply cord or turn off the electrical power.

2.Open lint screen lid. Remove two screws from lint screen area.

3.Open top by pulling forward and up at each front corner (see View A). Rest raised top against wall behind dryer (top is hinged at rear).

4.Remove two internal screws from front panel flanges (near top front corners). Lift front panel slightly, lifting off lower clips (see lower clip inset of View 13).Slowly pull front panel forward, disengaging panel from drum. (Drum will drop slightl,y.)

5.Move front panel aside and rest edge against side of dryer. Avoid disconnecting wire clips (see wire clips inset of View B) or damaging wires.

6.Remove lint from area shown in “gas dryer” illustration on page 14 with s’oft brush or vacuum cleaner. Avloid darnag,- ing wires, funnel, or ignitor.

7.Reassemble in reverse order. Before closing the top, check the following: -Drum seal must be flared o~ut(see

drum seal insets of View B) and p~*op- erly positioned against panel at back of drum. Rotate drum counterclockwise one full turn to check drum seal.

-Belt should be centered and tight Ion dryer drum.

-Wire clips which hold the door switch wires must be anchored in slot in top of front panel (see wire clips inset of View B) and along top edge of sid’e panel. Door wires must not touch drum when dryer is operating. See Warning, page 14.

8.Replace top panel and lint screen screws. Top and front panels must be securely in place before operating dryer.

9.Reconnect power and level dryer again (if necessary).

Remove screws before opening top

“’ View A

View B

For more information, call our

1

toll-free number 24 hours a day.

l-800-447-6737

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents UseAndCare Please record your model’s information Thank you for buying a Roper@ applianceYour safety is important to us Dryer SafetyUnderstanding your responsibilities Other doors Other features Not Parts and FeaturesStopping/restartin!g your dryer Operating Y’our DryerBefore starting your dryer Starting your dryerSelecting the right cycle and setting Drying guidelinesCycle descriptions Understanding the End-of-Cycle signal On some modelsWrinkle Prevent Automatic Cycle Drying cycles chartType of Load DelicatesNo Heat/Fluff or Air cycle, or line drying Type of Load Delicate FabricsCotton and Canvas Shoes Using the drying rack Available as an accessory onSome models Lint Scxeen Lint signal Every load Cleaning As needed cleaning Caring for Your DryerVacation care Cleaning the dryer interiorLint Removing accumulatedRemove screws before opening top ’ View a View B Drying tips Laundry TipsSorting clothes Choosing load sizesSaving energy Using dryer fabric softenersDrying special-care items ItemsDrying Instructions Napped items Troubleshooting Common laundrv problemsProblem Cause Common dryer problems If you need assistance If you need serviceIf you are not satisfied with how the problem was solved Reauestina Assistance orIndex What WE will not PAY for Dryer WarrantyLength of Warranty What WE will PAY for Full ONE-YEAR Warranty
Top Page Image Contents