| Options |
| |
EN | The options allow for customising the selected programme according to one’s own needs. |
| Delay start |
| |
| The start of some programmes (see Programmes and options) may be delayed up to 9 hours. Press the button repeatedly to |
| enter the desired delay time. Before setting a delayed start, make sure that the water container is empty and that the filter is clean. |
| Post |
| When this option is selected, the drum rotates garments at intervals after the cold drying cycle has ended, in order to avoid |
| creases forming on garments if they cannot be immediately removed at the end of the programme. During this phase, the indicator |
| light is turned on. |
| Pre |
| When this option is selected in addition to the “Delay start” option, the drum rotates garments at intervals during the delay period |
| to avoid creases forming. |
| High Heat |
| When a drying time is selected, pressing this button sets high heat drying and the indicator light above the button lights up. The |
| timed programmes are |
Not all options are available on all programmes (see Programmes and options). If the button of an unavailable option is pressed, the buzzer emits three signals. If an option is available, a single buzzer signal sounds and the option indicator light next to the button lights up to confirm the selected option.
Opening the door
If the door is opened (or the START/PAUSE button is pressed) while a programme is running, the dryer stops and the following may occur:
•The START/PAUSE button flashes orange.
•When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume the “Delay start” programme. One of the “Delay start” indicator light flashes to signal the delay time entered.
•It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running phase and the START/PAUSE indicator light stops flashing and turns green.
•During the post
•By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This procedure can be used to select the Cold drying programme to cool garments if they are judged to be dry enough.
Press the START/PAUSE button to start the new programme.
Note: In the event of a power cut, turn the power switch off and remove the plug; when the electricity supply returns, press the START/PAUSE button to resume the programme.
10