Washer-dryer description
| Control panel |
| FUNCTION | |||
|
| Buttons | ||||
GB |
|
| LOCK Led | |||
|
|
| ||||
| Leds |
|
|
| ||
|
|
|
| |||
|
|
|
| |||
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| Button |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Detergent dispenser
DRYING
Knob
START/RESET
Button
TEMPERATURE
Knob
Detergent dispenser: to add detergent and fabric softener (see page 12).
LEDS: to find out which wash cycle phase is under way.
If the Delay Timer function has been set, the time left until the programme starts will be indicated (see page 9).
DRYING knob: to set the desired drying cycle (see page 11).
FUNCTION buttons: to select the functions available. The button corresponding to the function selected will remain on.
TEMPERATURE knob: to set the temperature or the cold wash cycle (see page 11).
START/RESET button: to start the programmes or cancel any incorrect settings.
ON/OFF button: to turn the
PROGRAMME knob: to select the wash programmes. The knob stays still during the cycle.
Standby mode
This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the
Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by continuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.
8