Instructions for the fitter

Door Mounting Accessories (Fig. 1-2-3-4-5).

Mounting the wooden panel onto the door and inserting the machine into cabinets:

In the case where the machine must be shipped for final installation after the wooden panel has been mounted, we suggest leaving it in its original packaging. The packaging was designed to make it possible to mount the wooden panel onto the machine without removing it completely (see figures below).

The wooden panel that covers the face of the machine must not be less than 18 mm in thickness and can be hinged on either the right or left. For the sake of practicality when using the machine, we recommend that the panel be hinged on the same side as the door for the machine itself - the left.

N° 2 Hinge Supports

Fig. 1

N° 2 Hinges

Fig. 2

N° 1 Magnet

Fig. 3

N° 1 Magnet plate

Fig. 4

	N° 1 Rubber plug		N° 4 Spacers


Fig. 5		Fig. 4/B

-No. 6 type A self-threading screws, l =13 mm.

-No. 2 type B metric, countersunk screws, l =25; for fastening the magnet plate to the cabinet.

-No. 4 type C metric screws, l =15 mm; for mounting the hinge supports to the cabinet.

-No. 4 type D metric screws, l =7 mm; for mounting the hinges on the supports.

Mounting the Parts onto the Face of the Machine.

-Fit the hinge supports to the appliance front panel, positioning the hole marked with an arrow in fig. 1 so that it is on the inner side of the front panel. Fit a spacer (fig. 4/B) between the surfaces using type C screws.

-Fit the magnet plate at the top of the opposite side, using type B screws to fix two spacers (fig. 4/B) between the plate and the surface.