Indesit IWC 6105 Indicator lights, Starting a wash cycle, Set the spin speed see Personalisation

Page 7

Indicator lights

The indicator lights provide important information. This is what they can tell you:

Delayed start

If the DELAY TIMER function has been activated (see “Per- sonalisation”), after the wash cycle has been started the indicator light corresponding to the selected delay period will begin to flash:

As time passes, the remaining delay will be displayed and the corresponding indicator light will flash:

The set programme will start once the selected time delay has expired.

Wash cycle phase indicator lights

Once the desired wash cycle has been selected and has be- GB gun, the indicator lights switch on one by one to indicate which

phase of the cycle is currently in progress.

Wash

Rinse

Spin

Drain

End of wash cycle

Function buttons and corresponding indicator lights When a function is selected, the corresponding indicator light will illuminate.

If the selected function is not compatible with the program- med wash cycle, the corresponding indicator light will flash and the function will not be activated.

If the selected function is not compatible with another function which has been selected previously, the indicator light corresponding to the first function selected will

flash and only the second function will be activated; the indicator light corresponding to the enabled option will

remain lit.

Door locked indicator light

When the indicator light is on, the porthole door is locked to prevent it from being opened; make sure the indicator light is off before opening the door (wait approximately 3 minutes). To open the door during a running wash cycle, press the START/PAUSE button; the door may be opened once the DOOR LOCKED indicator light turns off.

Starting a wash cycle

1.Switch the washing machine on by pressing the ON/OFF button. All indicator lights will switch on for a few seconds, then they will switch off and the START/PAUSE indicator light will pulse.

2.Load the laundry and close the door.

3.Set the WASH CYCLE knob to the desired programme.

4.Set the washing temperature (see “Personalisation”).

5.Set the spin speed (see “Personalisation”).

6.Measure out the detergent and washing additives (see “Detergents and laundry”).

7.Select the desired functions.

8.Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in a fixed man- ner, in green. To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle.

9.At the end of the wash cycle the indicator light will switch on. The door can be opened once the DOOR LOCK indi- cator light turns off. Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the washing machine off by pressing the ON/OFF button.

7

Image 7
Contents Washing Machine Instructions for useSee figure InstallationConnecting the electricity and water supplies Unpacking and levellingRemoving the plug Replacing the fuseDisposing of the plug Disposing of the appliance First wash cycleTechnical data Detergent dispenser drawer Control panelStarting a wash cycle Indicator lightsSet the spin speed see Personalisation Table of wash cycles Wash cyclesSet for each wash cycle PersonalisationFunctions Table of wash cyclesPreparing the laundry Detergents and laundryDetergent dispenser drawer Load balancing systemGeneral safety Precautions and tipsDisposal Care and maintenance Problem Possible causes / Solutions TroubleshootingMachine is noisy Assistance Recycling & Disposal Information After Sales Service195082141.03 Essential Contact Information
Related manuals
Manual 16 pages 18.48 Kb