Indesit IWD 7168 manual Troubleshooting, Problem Possible causes / Solutions, See Installation

Page 13

Troubleshooting

Your washing machine could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure

 

GB

that the problem cannot be not solved easily using the following list.

 

Problem:

Possible causes / Solutions:

 

 

The washing machine does not switch on.

The wash cycle does not start.

The washing machine does not take in water (“H2O” will flash on the display).

The appliance is not plugged into the socket fully, or is not making contact.

There is no power in the house.

The washing machine door is not closed properly.

The ON/OFF button has not been pressed.

The START/PAUSE button has not been pressed.

The water tap has not been opened.

A delayed start has been set (see “Personalisation”).

The water inlet hose is not connected to the tap.

The hose is bent.

The water tap has not been opened.

There is no water supply in the house.

The pressure is too low.

The START/PAUSE button has not been pressed.

The washing machine continuously • The drain hose is not fitted at a height between 65 and 100 cm from the floor

takes in and drains water.

(see “Installation”).

 

• The free end of the hose is under water (see “Installation”).

 

• The wall drainage system is not fitted with a breather pipe.

 

If the problem persists even after these checks, turn off the water tap, switch

 

the appliance off and contact the Assistance Service. If the dwelling is on one of

 

the upper floors of a building, there may be problems relating to water drainage,

 

causing the washing machine to fill with water and drain continuously. Special

 

anti-draining valves are available in shops and help to avoid this inconvenience.

The washing machine does not drain or spin.

The wash cycle does not include draining: some wash cycles require the drain phase to be started manually.

The drain hose is bent (see “Installation”).

The drainage duct is clogged.

The washing machine vibrates a lot • The drum was not unlocked correctly during installation (see “Installation”).

during the spin cycle.• The washing machine is not level (see “Installation”).

• The washing machine is trapped between cabinets and walls (see “Installation”).

The washing machine leaks. • The water inlet hose is not screwed on properly (see “Installation”).

The detergent dispenser drawer is blocked (for cleaning instructions, see “Care and maintenance”).

The drain hose is not fixed properly (see “Installation”).

The “function” indicator lights and the “start/pause” indicator light flash, while one of the “phase in progress” indicator lights and the “door locked” indicator light will remain lit in a fixed manner.

Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again.

If the problem persists, contact the Technical Assistance Service.

There is too much foam.

The detergent is not suitable for machine washing (it should display the text

“for washing machines” or “hand and machine wash”, or the like).

Too much detergent was used.

13

Image 13
Contents Washing Machine Instructions for useConnecting the electricity and water supplies InstallationUnpacking and levelling See figureReplacing the fuse Supply voltage is included within the valuesRemoving the plug Disposing of the plugDisposing of the appliance First wash cycleTechnical data Detergent dispenser drawer ON/OFF buttonStarting a wash cycle Indicator lightsSet the spin speed see Personalisation Table of wash cycles Wash cyclesFunctions PersonalisationTable of wash cycles Set for each wash cycleDetergent dispenser drawer Detergents and laundryLoad balancing system Preparing the laundryGeneral safety Precautions and tipsDisposal This appliance was designed for domestic use onlyCare and maintenance Problem Possible causes / Solutions TroubleshootingSee Installation Free end of the hose is under water see InstallationGuarantee certificate ServiceBefore calling for Assistance Always request the assistance of authorised techniciansReplacement of any removable parts made of glass or plastic Guarantee195076142.00 After Sales ServiceEssential Contact Information Recycling & Disposal Information
Related manuals
Manual 16 pages 15.87 Kb Manual 16 pages 30.55 Kb