Indesit PWE 9168 S manual Troubleshooting, Problem, Possible causes / Solutions

Page 13

Troubleshooting

Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Service (see “ Service”),

 

GB

make sure that the problem cannot be not solved easily using the following list.

 

 

 

Problem:

The machine does not switch on.

The wash cycle does not start.

The machine does not fill with water or ‘H20’ flashes in the display.

The machine continuously fills with water and continually drains away or Water left in the drum

or Stuck on wash.

The machine does not drain or spin - (error lights flashing).

The machine does spin

The machine does not drain or spin

-‘EASY IRON’ & ‘START/PAUSE’ indicator lights flash.

The programme takes too long.

The Display sticks at one ‘time to end’ for more than 1 Minute or the Display changes the estimated ‘Time to End’ during the programme.

The machine vibrates a lot during the spin cycle.

Possible causes / Solutions:

The appliance is not plugged into the socket fully, or not enough to make contact.

There is no power to the socket, or the fuse has blown in the mains plug.

The door is not closed properly.

The ON/OFF button has not been pressed.

The START/PAUSE button has not been pressed.

The water tap has not been turned on to allow water to flow into the machine.

A delayed start has been set.

The water inlet hose is kinked.

The water inlet hose is not connected to the water supply.

The water pressure is too low.

The water tap has not been turned on to allow water to flow into the machine.

There is no water supply to the house.

The inlet valve filter is blocked.

The START/PAUSE button has not been pressed.

The top of the drain hose is too low - It must be fitted at a height between 65 and 100 cm from the floor (see “Installation”).

The drain hose is connected incorrectly to the sink trap allowing water to run into the machine, the drain hose must be positioned higher than the bottom of the sink to prevent water flowing down the drain hose.

The end of the drain hose has been pushed too far down the standpipe, the ‘U’ bracket should be fitted 100 mm from the end of the drain hose.

The Pump filter is blocked.

The drain hose is kinked (see “Installation”).

New Installation - The blanking cap or spigot has not been removed if connected under a sink.

The drain hose or sink trap is blocked.

The Spin Speed is set to “OFF”.

If the ‘EASY IRON’ option is enabled, at the end of the program the machine drum will rotate slowly. To complete the program press the ‘START/PAUSE’ or the ‘EASY IRON’ buttons.

If the ‘DELICATES’ or ‘OUTWEAR’ programs are selected, at the end of the program it requires the drain phase to be started. To complete the program press the ‘START/PAUSE’ or the ‘EASY IRON’ buttons.

Programme times will vary due to water pressure, the incoming water temperature and if the wash load goes out of balance. This will increase the programme times accordingly (see ‘ The machine wont spin properly’ below).

The display time is for guidance only - it is not a precise time to finish and may vary.

The feet have not been adjusted, enabling the machine to rock.

New Installation - Either the Transit Bolts including the plastic spacers, or the

Polystyrene Packaging have not been removed when installing the machine.

The machine is trapped between cabinets and/or walls.

The load is in a slight out of balance condition and machine is spinning, but at a lower speed.

13

Image 13
Contents Washing Machine Instructions for useConnecting the electricity and water supplies InstallationUnpacking and levelling Make sure that the hose is not folded over or bent65 100 cm Supply voltage is included within the valuesFirst wash cycle Technical data Control panel Description of the washing machineDisplay Running a wash cycle Switch the Machine ON. PressBlue colour To open the door while a cycle is in progress, pressTable of programmes and wash cycles Wash cycles and optionsWash options Detergent dispenser drawer Detergents and laundryPreparing the laundry Special wash cyclesGeneral safety Precautions and tipsDisposal European Directive 2002/96/EC on WasteCleaning the washing machine Care and maintenanceCleaning the pump Clean the inside thoroughly Screw the lid back onProblem TroubleshootingPossible causes / Solutions Page Assistance Replacement of any removable parts made of glass or plastic195083836.01 After Sales ServiceEssential Contact Information Recycling & Disposal Information