Hotpoint WF 566 P Personalisations, Setting the spin cycle, Setting the temperature, Functions

Personalisations

Option buttons

Setting the spin cycle
If, when the appliance is switched on, the KNOB is positioned on			G B
a programme with a spin cycle, a fixed		appears. Press
button	and the maximum spin speed allowed for the
programme set will be displayed, and the		icon flashes.
Press it again and the values lower until they reach OFF, which
indicates that the spin cycle has been excluded (press it again
to go back to the maximum value); stop on the desired speed,
after approximately 2 seconds the setting is accepted: the
symbol	remains fixed. The spin cycle setting is enabled with

all the programmes except for 11 and the Pump out cycle.

Setting the temperature

If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature

needs to be regulated, a fixed appears. Press button and the maximum temperature allowed for the

programme set will be displayed and the icon flashes. Press it again and the temperature lowers until it reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the

desired value, after approximately 2 seconds the setting is accepted: the symbol remains fixed. The temperature adjustment is enabled with all wash programmes.

Setting the delay Timer

Press the button and you will see the word OFF on the display, while the relative symbol flashes.

Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the "desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the set

programme appears on the display and the symbol remains on.

If you now press the START/RESET button, the set "delay" appears; this decreases every hour until the start of the cycle. In this phase, the "delay" can only be modified by decreasing it.

The Delay Timer regulation is enabled with all programmes.

Child Lock (see page 7).

Functions

To enable a function:

1.press the button corresponding to the desired function, according to the table below;

2.the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.

If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled.

Function	Effect	Comments		Enabled with
				programmes:
	Allows for an
	impeccable wash,			1, 2, 3, 4,
	visibly whiter	This function is incompatible with the RAPID function.
				5, 6, 7, 8.
Super	than a standard
Wash	Class A wash.
	This option	When this function is set, programmes 6, 7, 8, 11 and "Rinses &		All
	reduces the
		Slow Spin" will end with the laundry left to soak (Anti-crease)
	amount of			programmes
		and the Rinse cycle phase LED will flash.
	creasing on			except for
		- to conclude the cycle, press the START/RESET button;
	fabrics, making			1, 2, 9, 10 and
		- to run the draining cycle alone, set the knob to the relative
	them easier to			Pump Out.
Easy Iron		programme	and press the START/RESET button.
	iron.
	Cuts the
	duration of the	This function is incompatible with the SUPER WASH function.		1, 2, 3, 4,
	wash cycle by			5, 6, 7, 8.
Rapid	30%.

9