Installation
GB | ! Read these instructions carefully: the following | ||
pages contain important information on installation | |||
| |||
| and suggestions on how the appliance works. | ||
| Unpacking | ||
|
|
| |
| 1. Using scissors, cut |
| |
| carefully along one corner |
| |
| post to remove the film. |
| |
|
|
| |
2.Open the door and check inside the drum.
Remove the transit tube (if applicable - not all models).
!Retain all packaging material until installation is complete.
3.Lift off the polystyrene top cap and remove the four corner posts.
4.Carefully lay the left side of the machine down onto the top cap.
!We recommend that a second person helps to raise and lower the machine.
5.Remove the polystyrene base.
!IMPORTANT check when unpacking your machine:
6.Cut out the perforated shape in the transit tube you removed from the drum (if applicable - see Step 2). Follow instructions listed on the cut out to fit it to the base of the machine. When fitted this panel aids noise reduction.
7.Stand the machine upright.
!We recommend that a second person helps to raise and lower the machine.
!Continue to read the rest of these instructions carefully; the following pages contain important information on installation and troubleshooting.
!This is a part of the polystyrene base and should have stayed intact when you removed the base.
!If it has broken off and is still in the machine...
remove it... while the machine is still laying on its side on the top cap.
!Protect the environment - please dispose of the packaging material carefully and considerately.
4